Hi,
I've been troubleshooting my generator in my 380 DA for a while now. Typical start and run until you let go of the "preheat (sensor bypass)" switch. All the sensors and K1/K2 relays check out.
I had a specialist come out recently and he said that the CO detectors are wired to a relay that...
Thanks for the replies.
Weird stuff going on...
Voltage readings at batteries are around 14 volts. Reading at power-in and load sides of port and starboard solenoids is 14v when energized (shore power on). De-energizing the port side reads 14v in and 0v out. De-energizing the starboard side...
More information...
Batteries are in fact not dead. They measure 14 volts with the solenoid energized or not (not charging). The solenoid operates fine. Charger is sending 12 volts to the solenoid.
My problem therefore must be north of the batteries. Why would the house systems show zero volts...
Hi all. I am really frustrated... please read to the end so you understand the facts and I really hope someone can help me.
My starboard side batteries keep needing replacing. I paid the marina where we wintered to remove all the batteries and place the in dry storage, but they didn't.
We...
Hi,
I posted the below in the official 380 thread and all I got was sympathies. I'll try to summarize to see if anyone knows where I should start...
Configuration:
- 2000 380 DA with 2 port batteries (engine) and 2 starboard batteries that are new (engine and house)
Symptoms:
- On shore power...
Hi all. I am really frustrated... please read to the end so you understand the facts and I really hope someone can help me.
My starboard side batteries keep needing replacing. I paid the marina where we wintered to remove all the batteries and place the in dry storage, but they didn't.
We...
Hi,
I need to replace my water heater in my 2000 380 Sundancer and measured it at about 11 x 11 x 13. I'm guessing that the dimensions for the common replacement 6 gallon heaters at 13 x 13 x 19 will fit, but was hoping someone can confirm.
Thanks,
Michael.
Hi,
I have two new 454 MAG MPI engines in my 380 and have developed an oil leak. The leak is from the hose fitting going into the oil filter hosing. Since I can't find an exact match to these hoses online I think I'm going to use braided stainless steel an make my own.
While searching for...
Hi,
I've purchased two NOS systems monitors over the past 4 years and both had the LCD display fail so you only see part of the text. Anyone know of an upgrade or alas, a source for yet another replacement?
Thanks.