Recent content by Cleach

Does SeaRay sell a replacement cable? If it is not the cable, can I get a new sending unit? Thanks

Thanks.

Great!! Thanks.

Thanks. I will give it a try.

I have a 2006 SeaRay 320. It has two banks of 2 batteries for 4 total. What is the best way to store the batteries. I was thinking about disconnecting 3 of the batteries and only leaving one house battery connected with an external solar charger on it. I need at least one battery connected to...

I have a 2006 SeaRay 320. The Systems Monitor displays "Data Link Failure: Alarm System Offline". I unplugged the fuse at the Monitor box in the bilge area and that disabled the display. Does anyone have suggestions as to how to track down the problem? Thanks for your thoughts.

I replaced the pump as well. It was bad.

Thanks everyone. I replaced the float switch and pump in the shower box and the error message went away. This is a great site.

Do you mean the shower pump or the Systems Monitor> Thanks

Thanks a bunch for the guidance. I will check the shower pump out tomorrow.

I have a SeaRay 320 with the SeaRay Systems monitor. It displays continuously "Pump Alarm Forward Sump". The forward sump appears to be working properly and when manually activated reads forward sump emergency on. Any ideas on why or how to disconnect it or reset it?

Thanks for the good advice.

Hi Everyone, I have a 2006 SeaRay 320 with four AGM 12-volt batteries. I hear many opinions about the best way to store it. The boat is stored in Mexico for 7 months a year. Some say it is best to fully charge the batteries and then leave them disconnected. Others say it is best to leave the...

Well, after a long and sad tale of less than competent mechanics, one of them finally figured out that it was my PCM by switching the port and starboard PCMs and seeing that the swap did cause the starboard engine to have the same "Lost Engine Com' error as the port engine had. I guess the new...

Is the cannon plug the big round blue one on top of the engine that goes nowhere? I will clean it as well. I did clean the 3 plugs that go into the PCM. They looked good. I will clean the panel gauge connectors next. I did loose the panel gauges when the lost engine com warning came on. I...