Recent content by Jeffrey King

  1. Jeffrey King

    Official 2003.5-2008 340 Sundancer Thread

    Thank you and yes, I plan on changing the fluid as well.
  2. Jeffrey King

    Official 2003.5-2008 340 Sundancer Thread

    Hi Everyone, I am preparing to replace my transmission coolers. Seems to be a fairly easy job, but i have a question about the diamond step on the port engine. Any issues with removing the nuts holding it to the transmission ? I won't break a seal? Thanks in advance!
  3. Jeffrey King

    Official 2003.5-2008 340 Sundancer Thread

    Hi Randy, I had the same issue a few weeks ago on my port side engine. Engine completely died and port side gauges were frozen (i.e. tach was stuck at 3000, etc, etc) I reached out to Mercruiser and they suggested i check all the ground connections They also recommended I replace the old...
  4. Jeffrey King

    496 mag engine code

    Hi Willy G, I recently installed the Vessel View Mobile kit for this very reason. Once installed to the SmartCraft Junction Box under the helm dash, you use an application on your phone and connect via Bluetooth. If you do get an alarm, you will get a human readable message that clearly...
  5. Jeffrey King

    Official 2003.5-2008 340 Sundancer Thread

    Kohler 359771 Oil Filter for 4EF, 5E, 6EF, 7.3E Generators : (partsfortechs.com)
  6. Jeffrey King

    Official 2003.5-2008 340 Sundancer Thread

    Hi, From the screen, it looks like the STBD engine has high water pressure at idle. 43.5 psi Faulty sensor perhaps? if you throttle up, does the pressure on the stbd engine change ? port engine at 2.5 looks normal idling @ 650 The alarm mentions fuel level so that is confusing
  7. Jeffrey King

    Official 2003.5-2008 340 Sundancer Thread

    Hi Outobie, check this out...Maybe one of these is a good substitute Marine Reading Lights (drsa.com)
  8. Jeffrey King

    Official 2003.5-2008 340 Sundancer Thread

    Hi Outobie, I believe this is the searay part number, 1831205 I would try calling MarineMax parts dept to see if they still carry the part or if they have an equivalent
  9. Jeffrey King

    8.1 Mercruiser Problems

    Hi Everyone, Need advice & feedback I was running the boat yesterday. I was out for a few hours a various RPM's. i was almost home and got the boat up to 3100-3200 RPM's. after about 5-10 mins at that RPM, the port engine shutdown. i mean completely off. gauges stuck at their last position. i...
  10. Jeffrey King

    Official 2003.5-2008 340 Sundancer Thread

    Hi Everyone, Need advice & feedback I was running the boat yesterday. I was out for a few hours a various RPM's. i was almost home and got the boat up to 3100-3200 RPM's. after about 5-10 mins at that RPM, the port engine shutdown. i mean completely off. gauges stuck at their last position...
  11. Jeffrey King

    Warning Alarm Help (Again) 2002 320DA

    I ended up installing VesselViewMobile It gives you the smart craft alerts in human readable form. Very easy to figure out alerts, etc ,etc.
  12. Jeffrey King

    Warning Alarm Help (Again) 2002 320DA

    ICA valve ? Did you mean, IAC valve ?
  13. Jeffrey King

    Official 2003.5-2008 340 Sundancer Thread

    Hi Everyone, New topic... Best way to check the Heat Exchanger, Trans oil cooler and oil cooler to see if they need to be replaced ? i.e. For heat exchanger, is it simply pulling the end caps and checking ?
  14. Jeffrey King

    Removing Switch Panel

    ok. i am not going to mess with something that only requires a simple toggle switch. i am starting to have an issue with my DSM300 module to my C80. it intermittently stops sending to the C80 and when i unplug and plug in the power, the data feed restarts. I was thinking of using an unused...
  15. Jeffrey King

    Removing Switch Panel

    Thank you !
Back
Top