KevinC's Recent Activity

  1. KevinC replied to the thread is it time to replace the risers?.

    I am guessing you mean the elbows. Do you know when they were done last? If not it's time to at least have them inspected and plan for a...

    Sep 25, 2020 at 6:44 PM
  2. KevinC replied to the thread Waste Line Seacock.

    ... and possible even wired shut if traveling into fresh water rivers and lakes. -Kevin

    Sep 25, 2020 at 2:59 PM
  3. KevinC replied to the thread 2008 340DA water heater.

    Unfortunately I don't have a picture handy but on mine the upper left output has a smaller riser and a mixing valve. The mixing valve...

    Sep 25, 2020 at 2:56 PM
  4. KevinC replied to the thread 2008 340DA water heater.

    Facing the unit cold water should enter on the right side and the hot water should exit on the left. There may be a cold water crossing...

    Sep 25, 2020 at 9:25 AM
  5. KevinC replied to the thread Soldering battery lugs.

    Crimping is definitely the recommended method here and because of the wire size you may need a hydraulic or hammered crimp. -Kevin

    Sep 24, 2020 at 12:40 PM
  6. KevinC replied to the thread Official 2003.5-2008 340 Sundancer Thread.

    If you have the XMD-3 there is only one set of AUX-IN plugs so if you have some in the cabinet and they work then a previous owner must...

    Sep 24, 2020 at 12:38 PM
  7. KevinC replied to the thread Official 2003.5-2008 340 Sundancer Thread.

    You probably lost the prime on the water flow. The A/C pumps are not self priming and can not pull up water on it's own. There are...

    Sep 24, 2020 at 12:31 PM
  8. KevinC replied to the thread EIM to Toggle and Rocker Switches.

    That is true that these are fairly low loads. The EIM would require them since it is a computerized control box and the keypads do not...

    Sep 24, 2020 at 12:26 PM
  9. KevinC replied to the thread EIM to Toggle and Rocker Switches.

    While this looks great I do not see any relays. My question here is are you carrying the full load through the dash switch? That can...

    Sep 24, 2020 at 12:15 PM
  10. KevinC replied to the thread EIM to Toggle and Rocker Switches.

    Apparently the same engineer that put the cockpit speaker switch closer to the cabin and the cabin switch closer to the cockpit. ;) I am...

    Sep 24, 2020 at 12:11 PM
Show Sidebar