Separate names with a comma.
Older post - but just checking to see if you ever got your Generator issues resolved?
Let me know what you want for the gauge set (fuel, temp, oil, rpm, etc), and the set of carlington switches below the gauges. Not sure if the...
As I started looking for parts- it seems easier/less expensive to follow what you did. The kits have everything you need with the inline tees....
With the original 7.5KW, you could basically run everything (including water heater) - until you get to the stove. When you scale down to the...
Just a reminder - did you check your anodes and bonding system? It sounds like the paint will definitely help, but you need a working anode...
Nice work! Curious (because I have to do a similar project) - did you investigate using the 'existing tee w/ bleed nipple' on the steering...
If most are actually reading what ChipS is posting - I would be surprised. A) He knows the sending gauge was replaced by PO B) He knows what the...
Here are some numbers to put things in perspective, using some general assumptions regarding what you might have onboard. Since you dont use the...
What are the conditions of your anodes, and where/how many do you have? Is your bonding system still intact? I am trying to decide of I should...
Q: Doesnt painting the props reduce galvanic reaction, as there is less surface area exposed?
Converting the fuel type would most likely require a new carburetor, given propane is a gas (vapor) and gasoline is a liquid. Air cooled wont...
You probably have a Fram fuel filter behind the cross over valves. Its a canister with a internal filter that can be replaced. I use a WIX33110...
If you disconnect #85 and the engine still shuts down, then I would suggest trying to hot wire the engine. This in effect removes the Engine...
Here's the manual for the QS-4.0G, QS-6.5G, and QS-8.0G. For full disclosure - I just found it online, and aside from a quick skim - it appears...
That looks to be the easiest and space conscious apparatus I’ve seen yet. What does that arrangement cost? I only see links for requesting a quote.
