Recent content by Nauti 97

When I bought my 380 2 years ago the tachs showed starboard at 802 hrs and the port showed 515 hrs. before I purchased I paid a mechanic to do an engine survey. he checked compression on each Cylinder and plugged into the ECM on each motor. compression on every cylinder was within 5 psi on every...

As I stated last year “Great post, Thanks! I still have the original fridge in my 2000 so I am sure I will need this in the future.” Well it happened it’s done for this year. So I will be taking on this project in the near future. Are the front Panels from the DE461 able to be installed on the...

For Sure!

Rivers Edge Yacht Club

No worries! I always like helping out fellow 380 owners. Especially ones from my home port

NespoJoe I once removed a deck hatch for the bow of a 370 Sundancer. I took off all of the trim and removed all of the screws. Then I took a thin wire (like piano wire) and kind of sawed under the edge and cut all the way under the caulk all the way around the hatch, and then lifted it right...

Mine was already updated when I purchased the boat. It’s a Fusion UD750.

no cam lock on ours. That was later models. I think they found that the spring cylinders could not hold the load over time. I am trying to figure out a way to add a cam lock to mine and my buddys.

Good evening SC, I removed my helm seat from the base plate that is bolted to the floor last winter. It would not swivel, slide, or go up and down. Everything was froze up from 20+ Years of not being used. Original owner set it and left it. I completely tore it apart. Actually it’s pretty simple...

Are the E127 NEMA2000 compatible? Are they functional? How much for them?

This is the one that I usused

If you Have all of your waypoints saved already a route plan can be completed in the amount of time it takes for the engines to warm up, and the lines to be pulled, unless you leave the dock immediately without warming them up.

I’m with Bill collector! There is no cost and no work involved with turning on electronics after engines are running. I have always done that. What is the advantage in having them on before start up? You don’t use them until the boats moving anyway.

41 ft.+ anchor Boat is 38ft platform is 3ft I have a 40 foot dock and if I bow all the way in the anchor hangs over the sea wall and About a foot of swim platform hangs out.

I have been in the forward storage area several times. The shower sump has never overflowed and the entire storage area is bone dry. I think I am going to cut the wires on the Pump just aft of the shower sump as gallf1 has suggested. If that works then I will replace the switch. Probably the...