Hey guys, did you ever replace an oem pistons with some aftermarket ones? I have low compression on 4 cylinders. We completely took apart the short block and found these 4 piston rings stuck, rusted, broken and we are not even able to take them out. Cylinder wall looks good with no obvious...
Hey guys, we just replaced the heads, basically took electric harness off and we put everything back together..now, I am not getting any power for ignition switch.. normally I have to turn the key on and ignition switch as well, there is a long beep and it's ready for start..(there should be a...
Hey guys, we just replaced the heads, basically took electric harness off and we put everything back together..now, I am not getting any power for ignition switch.. normally I have to turn the key on and ignition switch as well, there is a long beep and it's ready for start..(there should be a...
Hey guys, did you ever heard about some "mercruiser alive wire"? I saw other post with similar issues and that guy was saying his alive wire was disconnected.. Any idea where is it located? Thank you!
Hey guys, is here somebody who went through that process of removing the 496 engine from the sedan bridge and can share some pictures and tips with me? I will really appreciate that, thank you!
Water get in there probably when I was flushing the engine with a fresh water..I put the mystery oil in the cylinders immediately and let it sit for like a week.. everything was just fine and engine was running like a butter till last week when the issue began..we found 4 cylinders are giving me...