The bulbs on my energize switches are burnt out, and I would like to replace the bulbs. The switches still work. Does anyone know where I can get replacement bulbs and or part numbers?
According to the part manual the switches are. I have a 2005 Sundancer.
681494 BODY, ROCK SW DPDT MOM 12V...
There is some slight scoring and it ran good prior to the impeller change. We also didn’t let the engine run long enough to over heat. We did let it run for about 1 to 1.5 minutes and still no water pumped out. We also put a garden hose into the line feeding the pump. It seem to pump at about...
Does anyone know what the cylindrical part of the 8.1s Horizon water pump does? I replaced impeller on starboard engine, re-attached hoses and I can’t get the water shooting out the side of boat, I actually pulled the pump twice (to review my work) as it didn’t work the first time, and it’s not...
This spring while waiting out covid19 I plan on installing a drain plug light and a port side arch mounted 12v Tv on my 2005 Sea Ray 340 Sundancer. I need advise on the how to supply power to these units.
1) where is the best place to connect the TV 12v power wire so power is supplied while on...
Rick, you seem to have a good understanding of the EIM, many thanks. Just curious, if it’s circuit protected (fused) why are so many units failing. I just want this project to go smoothly and to prevent any costly screwups.
Also, do you know what company or companies are building the replacement...
I plan on adding a drain plug light on my 2005 340 Sundancer and connecting it to the aft EIM Accy2 which I believe is spare. I realize that the EIM is a very expensive and hard to replace item. Previous posts have indicated caution and or a reluctance to connect to this sensitive module. What...
My 2005 SunDancer is currently under winter shrink wrap. As soon as they open the marina my plan is to change the leaking rudder packing. I want to have the packing in hand but not sure of the rudder shaft diameter. I think it's 1.5". Does anybody know for sure what the shaft diameter is?
Thanks
I am considering replacing my arch lights with the Lumitec full color spectrum lights. Adjusting the color and intensity of these light requires frequent pressing of the arch light on the EIM switch panel. Has anybody had experience with these lights using the Sea Ray EIM system? How robust is...
Korkie, I was determined to figure this out myself but alas. I have Smart Craft Systems gauges and have read what I could on it's operation but was not able to figure out how to set the voltage alarm....water depth alarm yes, but not a battery voltage alarm. Could you point me in the right...