I replaced the Crank Sensor today and let the boat run for an hour. Engine was at full temprature and the hatch was closed.
I did put in a crank sensor from a 2002 Chevy Surburbon 8.1 and it was 74.99
Thanks for everyone's help!
For future reference to my fellow boaters. This part took a whole...
So I came up to the boat and was ready to pull out the crank sensor but tried to start it to make sure I still have the same issue. Guess what, it started and sounded fine.
I let it run with the hatch open and revved it a few times, all good. I closed the hatch and left it idling and a few...
I have a similar issue. I was out this weekend cruising around 25knts and started to throttle down and my starboard engine died. It just stopped, no sputtering. It cranks fine, has fuel pressure in the rails but doesn’t have spark. It didn’t throw any error messages on the system monitor either...
Thanks Chris. I called Southcoast marine and they asked for the part number of the Anchor.
Any idea about the part number or can you recommend a galvanized one?
I see the Delta type anchors but not sure of those are the right ones.
I have a 2002 380 Sundancer and I lost my anchor last weekend. I’m looking for a new one and need to know the weight of the one that came originally. Was it 35 or 22 lbs. I’m on lake Lanier so it’s pretty tame. thanks for your help.
Ray
I’m replacing the stereo and removing the 6 disk changer. I have a new fusion head unit and want to replace the off white melamine board and cut a new hole.
Does anyone know where I can find a replacement board without holes?
Thanks,
Ray
2002 380 Sundancer
I have a 2002 380 Sundancer. The outlet in the kitchen isn’t working. I also noticed the coffee maker is hardwired to somewhere and I want to remove it. is there a hidden outlet or GFI?
After a bunch of research and information from my fellow Sea Ray friends I decided to get a replacement fridge. I got the Norcold DE0061 and it will be delivered in a few weeks.
I haven’t decided if im going to do this myself or find someone.
I got the plugs changed. The socket size is 13/16 thin wall with a a wobble extension.
The plugs were shot and wasn’t firing on 3 cylinders. New plugs and it ran smooth but there’s gas in the oil so that’s getting changed.
I have a 2002 380DA and the engine is running okay with no load but it struggles when there is a load placed on it. It also smells like raw gas. It’s not blowing black smoke.
I want to try to change the plugs to start with but I can’t get the right socket on them. is there a special socket or...