Separate names with a comma.
The motor has been flushed and the oil wasn't clumpy or didn't contain any debris. Had an analysis done on the old oil and it came back fine, no...
The boatyard pushed me off till the end of April to do the oil pump replacement. I’m stuck at doing 8knots till then.
Have you ever bought anything from this site? It seems a little sketchy.
No one has them in stock
Thank you.
I need help finding a Westerbeke 46874 Magnetic Sensor 3/8Nf 1.43Lg in stock, or an alternate manufacturer's part that will work. Thanks
[ATTACH] Speed controller board looks like it has a fried spot on it. [ATTACH]
Yes.
Thank you so much for the help; I ordered the unit off eBay, keeping my fingers crossed, and will report back with results.
See the attached
Does anyone know if there is a different manufactor’s controller that will replace a Westerbeke controller govnr 12/24 no over 046945. Westerbeke...
My mechanic has no skin in the game, but when he sent me the compression test results, I needed validation that those numbers were correct. He did...
I have a 1992 Mercruiser 454 with 1300 hours. It burns zero oil and seems to run strong, besides an oil pump issue. My mechanic did a compression...
Does anyone know where I can find an aftermarket engine block for an 2011 Westerbeke 5.0 BCG gas generator? Westerbeke wants $3,600.00 for the...
Has anyone heard of flushing a Westerbeke gen incorrectly and getting water into the engine? It looks like that is what I did, not know much about...
The boat comes out of the water Feb 22nd for a bottom job, and I'm going to replace the oil pump on the port engine at that time. I’ve taken the...
Correct
Found out in 2015, heads and risers were replaced.
The plan B is in the back of my head, I’m hoping if I don’t have those thoughts it won’t be the problem and I won’t need plan B. All kidding...
