Separate names with a comma.
I am going to replace one bank of batteries On my 450. Currently have two group 27’s on the stbd bank and was going to buy two group 31’. I...
Quickest way to know if it’s sea water is give it a taste.
Fuses on both sides of the solenoid were fine when I checked them yesterday. Actually the first place I looked after reading your previous post....
My windlass switch at the helm doesn’t seem to be working. Foot pedals at the bow are operating normally. I haven’t unscrewed the dash panel yet,...
I was speaking with a fiberglass guy who told me he had done a job a few years back. Had to cut the hull sides to remove thee leaking tank. I...
I called boat zincs directly and got a bunch for a few cents each. Prob more In Shipping than cost for 12 of them.
Ended up modifying a pipe wrench. Cut the wrench short and Welded a 1/2 drive socket to wrench. Should be able to use an extension and a breaker...
Thank you
[ATTACH]
Anyone know the actual size for the hex nuts on the rudders for our boats? Have a slight packing leak and look to pick up a crows foot type...
That is actually amazing.
I haven’t tried the others, but this has been an on going debate. At some point pulling the trigger has to happen. I was trying to covey that if...
I’m going to save you some time. All this bullshizzle bubble gum Is nonsense. Ingredients: Compound. -3m super duty , only if you need it....
Orpine
I’d be hesitant to wet sand that spot with the vinyl decals right there. I’d try 3m compound on a wheel. Wet it a little. Then a good polish...
I was going to switch up this season and move to the smoove products but decide to stay with the same I’ve been using the last few years. Presta...
One last question, the link looks like a single blade, or was it a set of two? Just ordered two, but wasn’t sure…
Thanks bud!
