Separate names with a comma.
BTW, I changed the IAC valve because engine cannot start, it helps a little, but still have problem to start from cold engine, unless it’s warmed.
Both batteries and charges are dead, replace them with new. now seems works fine. But I have another post about the speed problems. Need more help.
Hired a diver Clean the bottom and prop. Run out and got a little good speed, but still max at 18 miles and 3.5k RPM.
Yes, it’s been sitting water for 5 months, will try to get a picture.
My boat only goes up to 8 miles even I push throttle all the way down. RPM -3k.
I googled maybe three problems: spun prop, debris around prop or...
Thanks a lot!!!
Thanks, I don’t use hot water a lot. I might just bypass it.
Yes, it was a bad fuse. Even though it did not look bad to me, after I changed, the hatch worked.
Thanks Gord, do you know what these two pipes for and how to bypass?
Found out the water heater pipe rusted. See pictures.
How hard to fix it myself? Do I need to replace the whole water heater? Seems salts...
I was able to get it worked!!! Finally.
I changed all the fuse under helm even though they seemed okay. I believe they are rusted during the...
I don’t hear any sound from the hatch. The door was open completely for sure. But I have to go there tomorrow to double check. I need do some...
thanks. but the hatch stops 1 inch I tried to lift up, the tension is up, I tried to step on it push down, did not work. either Hatch has fuse (if...
thanks, when I connect the external battery, the blower and all lights are working fine. radio is on, only the hatch is no movement. do you know...
great! I didn't think about that. let me try.
I thought so to lift up and release the tension, but no way to grab the heavy hatch.
Thanks. I found that pin, but due to the tension, the pin cannot be pulled out easily.
I used screw driver to pull it, the ring ripped.
My boat is 2006 Sundancer 260DA.
I know this is a common question about the opening the hatch, but my case is very complicated. I hope...