Separate names with a comma.
He is my friend who is helping me get the boat running. He's way more technical than me.. I'm doing good to sputter sentence fragments from time...
It actually the type with a multi button panel that connects to an EIM.. unfortunately.. the panel is super hard to find and expensive.. ;(
The solenoid seems to be working. If it was solenoid would it only work in one direction?
You guys are awesome.. update..
Starboard Trim Tabs.. work up and down
Port trim Tab.. works up but will not go down
Starting to think that the...
One know where the EIM is located?
Is this the trim tab pump?
Will do! ;)
Henry,, that helps a TON! Will check it out.
One question.. IF Starboard trim tabs are working but port side just occasionally clicks, should I...
Adding my friend who is more knowledgeable to the thread.. @IRDaleBracey
I'll take a look! Thank you so much for taking time to answer! I'm learning all of this the hard way!
Amajamar.. I'm a bit clueless.
Twin 305 Mercruiser.
That hydraulic pump pictured is on the port side of the bilge. There is an identical pump...
Here is an image of my trim tab pump.
Checked out the doc and looks like my trim tab hydraulic pump isn't the same.. Also the helm has a sealed panel and only has 4 wires running to it.
Podt in snother are and it was suggested that i post here..
Trying to get my 2005 280 Sundancer ready for the slip.. So close! (Twin 305...
Thx.. ill look in that area!!!
Trying to get my 2005 280 Sundancer ready for the slip.. So close! (Twin 305 MerCruisers)
Ran into an issue and need your advice.
He was originally asking $895 with wiring harness.. I offered him $495 without the wiring harness.
He created that for just the ECM and told me...
Swaped the ECM from the working engine 1 to the non working engine 2 and engine 2 started up.
Anyone have suggestions on a replacement ECM?...
A fuse swap is an easy test! #FingersCrossed