Search results

  1. sr330daguy

    320 Part Out

    I’m looking for the swim platform Ladder and the vacuflush generator (depending on which model it is .Thanks
  2. sr330daguy

    Official 330 Sundancer Thread

    E EBay seller sjh326 has them
  3. sr330daguy

    Can you recommed a generator for my 260 sundancer 2004

    Westerbeke’s seem ( check out posts about Kohler issues) to have less issues than Kohlers and also run at a lower RPM which makes the quieter
  4. sr330daguy

    Can you recommed a generator for my 260 sundancer 2004

    Several here they ship.....https://boston.craigslist.org/gbs/bpo/d/kohler-marine-generator-5-73kw/7117153406.html
  5. sr330daguy

    Official 330 Sundancer Thread

    1 3/4 the top is dished approx.3/16
  6. sr330daguy

    Wanted Gypsy for lofran winless progress 1

    Progress 1 or 2? I have a progress one along with good motor and switch box
  7. sr330daguy

    Official 330 Sundancer Thread

    21 X 32 1/4
  8. sr330daguy

    Fire destroys Restaurant at Watch Hill FI

    Didn't see other thread
  9. sr330daguy

    Fire destroys Restaurant at Watch Hill FI

    http://fireislandandbeyond.com/
  10. sr330daguy

    Exhaust Bellows do they matter?

    Iv'e seen a few shift boots burn't through from boats without an exhaust bellows or tube...
  11. sr330daguy

    Official 330 Sundancer Thread

    https://www.ebay.com/itm/1949-1959-...ury-49-19268-1-/113786545549?oid=113693489245
  12. sr330daguy

    Bravo III stuck in forward at spring sea trial? 320 dancer

    Yes,if the shifter moves it may be that the shift cable didn't latch when the drive was installed.Make them show you.Go the the 4 minute mark https://www.bing.com/videos/search?q=bravo+3+shift+cable+latching+&&view=detail&mid=38E5F2342564F131E1E338E5F2342564F131E1E3&&FORM=VRDGAR
  13. sr330daguy

    Bravo III stuck in forward at spring sea trial? 320 dancer

    Does the shifter move to the neutral position ,and the drive stays in forward?
  14. sr330daguy

    Official 330 Sundancer Thread

    Taylormade sells paint to match in a rattle cans.
  15. sr330daguy

    Rebedding bow rails 1997 330 DA

    Todd, there are screws going up and down thru that assembly behind the mirror and tambor doors (keep track screw length and locations).You have to remove the 2 side upper panels in v birth along with the starboard bolster in the v.The assembly is a very tight fit, pull it slowly ,use extra care...
  16. sr330daguy

    Rebedding bow rails 1997 330 DA

    Front 2 stanchions are accessed by dropping the plastic panel under the pulpit.Remove the stainless insert and you will find the exposed self tapping screws that holds it in place.Going aft on port side remove v birth upper panel 3(screws in pleat).Next move to the cabinet just in front of tv...
  17. sr330daguy

    windless parts for progress1 windless for a 340da

    I have a good used control box and motor
  18. sr330daguy

    my luck... repower

    Mercury has quality rebuilds https://www.mercurymarine.com/en/us/engines/inboard-and-sterndrive/remanufacturing/
  19. sr330daguy

    Hull Vent Cover

    tdschafer a member here has a contact that is reproducing them
Back
Top