I have never been happy with the bow down since I bought the boat 8 years ago. I replaced the swim platform that came original with one from swimplatform.com. This summer all it took to get a big change was to put a small person up front between the hand rails on the bow and what a difference...
Yup, I had the forward hatch hing break. I had to replace it and found some water was getting into the core material. This spring going to pop out the center hatch since I found some soft spots in the same area as the horns. I have a feeling that the core material is wet and going. So I am...
I have done a couple of things when I redid the headliner. I did get replacement gasket since mine was brittle. But when I did the headliner, I sealed everything. Once everything was down and repaired the windshield wipers wires that I cut by accident, I took the nozzle of the caulking tube...
Check out my past project page. I had 2 of the above listed problems. Both where the windshield wires ran down the windshield and where the horn came through the top deck I also found no coring where the horns were mounted and that I was not the first one repairing it. There was several...
Well I just found this thread. Should have looked earlier. On this boat, did you sell the forward hatch yet? If you have not, is that the standard 20 x 20 hatch? You can measure the inside ring plate and if it is 19 5/16 there about, it will fit my boat.
Vic's Vapor rub under the nose does wonders! I was an EMT for 15 years and a few times had to pull decomposing bodies or those burned to death. The first one, one of the guys on the crew was passing the container around and I did not use it that time. No matter how much testosterone you think...
Taylor made. I will be replacing my soon. The late 89's used Taylor made systems
http://www.taylormadesystems.com/hatches/ultra3.html
and
http://www.taylormadesystems.com/hatches/privacy.html
I have a 2006 Suburban now. I wish it had a 5.7 (350cc) engine but they no longer have the 5.7 in the 1500. They have the 5.3 and it does not seem to have the towing power I was used too. While on trips I am getting 19 mph it just does not have the get up and go. I towed buddy's 24' fishing...
I do not like Fox News for the most part. But one of my friends posted this on Facebook. This is an active Judge in New York, who's name and address was published as a licensed gun owner. Boy does she hit the mark!
https://www.youtube.com/watch?v=1wGBqkzn24k&feature=youtube_gdata_player
Yes these stories do happen daily but never receive the attention of the press or acknowledged by the anti-gun movement of our government. If they did acknowledge it, they would not be able to continue the agenda to disarm America so they can have complete control over the people.
I looked all over the place trying to find them with no luck. Which handle port or starboard side? I am pulling out my hatch to see if I can repair the hinge. I was told by Taylor that they cannot be repaired. If that is the case I will have a starboard side handle
Well this was a poor newspaper and by publishing this list it generated a lot of revenue for the company. In NY State that information is considered public information. In CT Gun permit owners is not considered public information and cannot be divulged.
It is amazing, I guess under CT law, CT Gun owner information cannot be published. A state rep is pushing a bill to allow this to be published.
http://www.wfsb.com/story/20503381/new-bill-would-disclose-handgun-owners-information
First the only one that benifits from knowing this information are those who are not rational and those who are criminal in nature. Now they have a shopping list of where to break in and get any potential guns that maybe in the location.
Well I guess the news paper is afraid of all the gun owners it released the names of. The called the police about the emails, they said there was nothing that could be done. So the publisher hired arm guards for the office...