On the door rollers if you try Reflect Window & Door they might be able to help. If they don't have it you can send them a pic. Their site had a nice selection. Good Luck
Found one that matches online. The company is Prime-Line part #B 707. Roller is plastic w/metal ball bearing center. Comes with rivit to hold in the sleeve. 2 per package. Cost about 6$ They are 1 inch diamiter. Menards carry's this line but did not stock this part #. Hope this helps others.
thank you for the info. i think i found a replacement at reflect roller. waiting to recieve in mail. The roller I am replacing is the top roller and will see how it fits.
tired of hand pumping to flush. Could use some advice on which electric head to use. Would prefer to replace completly but open to using the conversion kit. Thank you.
I was thinking of using gr25 for port and two gr 27 for house and starboard. Switch is a off 1 2 also have a emergence cross over. Still have original sea ray charger in use.GR is group rating but I don't think they use that any more. Manuel calls for 105AH and GR27.
The quote for the shaft and coupling is with in a few bucks of my cost. I have a 30 weeknder and did the port 2 years ago. I don't think I would go the stainless route because it won't bend. If you had a stainless on it could have torn into the hull, resulting in hull damage. Shop for used or...
I am looking for used or new seat material for my 1988 30 weekender. I have owned her since 2001. I would like to replace the worn out material on one corner. I like this color and the material. Color is of the burgundy type. Also looking for the glass on the sea strainer? It cracked . Thanks...
Tom I have the same boat 88 weekender. Two years ago Ihad the same problem. I found a new one and it lasted less than a year. After checking with a norcold tec it was found to have a bad circuit board. They are no longer available. Rather then invest more money in a 23 year old fridge I bit the...
I have a 30 weekender 88. I added two more braces for a total of five. This way the weight is spread out more evenly. The core is plywood. I do scuba and with the extra weight I needed a more stable platform. Hope this helps. Frenchie
On the back of the tach you will see a slot to insert a common screw driver. This area will show four numbers 4 6 8 meaning 4 6 8 cylinder. Take your screw driver and rotate back and forth a few times. Then check to see if your tach is working. What happens is the copper oxidizes and it does not...
New to CSR but not boating. Have 300 Weekender 88 I got in 2001. Love the boat!! Looking for same type owners to share tips and ideas. Keep boat in Port Huron. Frenchie