Search results

  1. Team PCBeach

    High RPM overheat - Mercruiser 8.1

    2003 Sundancer 360, got an overheat on PORT engine during a trip yesterday when running at 3200rpm. Shut the engine down and continued our trip on the STBD. After about 15 minutes restarted the PORT and ran the rest of the trip at 2400rpm. Temp rose to 176 and held steady. STBD was running...
  2. Team PCBeach

    Vacuflush Vacuum Leak Repair success

    Just wanted to post my repair so others that might be in the same position don't have spend the time reading lots of old threads. 2003 Sundancer 360, vacuum pump started running every 3 minutes. Toilet holds water unless we are away from the boat for a couple of weeks. Vacuflush is new to us...
  3. Team PCBeach

    Vacuflush losing vacuum after duckbill/bellows replacement

    Vacuflush system on 2003 360 Sundancer. Systems started cycling the pump every couple of minutes. I took too long to address it and actually burned out the plump.Tank was holding water so my research said it was the duckbills. Replaced all duckbills and the pump bellows while had it off the...
  4. Team PCBeach

    8.1s - RPM issue under load

    Long post here, but wanted to include all information. 2003 Sundancer 360 with Merc 8.1s. 465 hours salt water both engines. Back in April/May had the boat hauled due to a vibration when on plane. This was after having the boat trucked from the Fl Panhandle to Jacksonville. Ended up having...
  5. Team PCBeach

    Leak in generator

    7.3KW Kohler, ran fine two trips ago last trip started up and ran for 10 seconds and then died. Won't restart. Acts like no fuel or spark. Removed sound shield to make sure was not low oil and oil was fine, but found what I think is a coolant leak. Looks like a very slow drip at the heat...
  6. Team PCBeach

    Fuel Sender Issue

    Cross posting here as the 360 Thread is pretty quiet in the winter.... 2003 360 with a port fuel sender issue. I had the marina look at it before we moved and they said the tank was not accessible so they just cleaned up some connectors. Problem still exists. Sometimes when we start up, the...
  7. Team PCBeach

    Mercruiser engine alarm issue

    2003 360 Sundancer with twin 8.1 Mercruisers. Went to run the boat today for the first time in two months (busy selling and buying a house). This was the first time we were running the boat after the marina had installed our rebuilt generator, which required removing the STBD exhaust. When...
  8. Team PCBeach

    Jacksonville Florida Info Request

    Anyone from the Jax area? We are planning to relocate to Jax in the next year. We will be on the East Side of town and are currently considering Palm Cove Marina or Beaches Marina for our 2003 360 Sundancer. Anyone have experience with either? Looking forward to being on the intercoastal and...
  9. Team PCBeach

    Systems Monitor Alarms

    We were out yesterday and started getting intermittent alarms on my Sea Ray Systems Monitor. This is on a 2003 360DA and while the alarm buzzer works but the LCD display shows no readout. I have Vessel View tied into my MFDs and got no alarms there. I thought it might be a bilge pump, but...
  10. Team PCBeach

    Generator Failure

    2003 360DA with 7.3 Kohler gas generator. Generator would not start, opened sound enclosure and the pan was filled with gas. Turned out the bottom of the carburetor had fallen off and sprayed fuel inside enclosure. Had marina make repair and all was good on next outing. Two weeks later start...
  11. Team PCBeach

    Fuel Gauge Issue

    2003 360DA having an issue with port fuel sensor. Filled up the tanks this weekend and while heading out fuel gauge would move around showing either full, empty or 1/2 tank. Same reading showing up on Smartcraft Gauge and on vessel view so I think it is s sensor problem not a gauge problem...
  12. Team PCBeach

    Factor carpet and canvas for 360 Sundancer

    I have a full set of topside carpet available. It is in very good condition as the previous owner pulled it and stored it in his house after every trip. No tears, all snaps, minimal wear. We replaced with SeaDeck. I also have all the front Eisenglass and the rear canvas that runs from the...
  13. Team PCBeach

    Battery Solenoids and Blower Switch

    Cross posting here since the 360DA thread seems quiet this time of year. I went to turn on the battery solenoids and only the STBD would come on. PORT and GEN would not come one. Thought it might be dead batteries since the boat has not been plugged into power for two months since the hurricane...
  14. Team PCBeach

    VesselView Link on 360DA or simliar

    Has anyone done a Vessel View Link on their 360DA or similar? I am going to do the install on our 2003 360DA to replace the badly faded Smartcraft display. Looks like an easy install if I have an open port on the SmartCraft hub. I have a 4 port hub at the helm behind the switches, but it is...
  15. Team PCBeach

    ST7001+ Autopilot Issue

    I have a Raymarine ST7001+ autopilot with S3G Course Computer on our 2003 360 Sundancer. Last week while underway the unit turned off. Cycled the power switch no joy. In my trouble shooting I have gotten to the point where I have power to the wire going unit, but when I connect the wire to...
  16. Team PCBeach

    Glomex Antenna Test

    New owners of a 2003 360DA. Any suggestions on testing the Glomex antenna? When we bought the boat all the TVs were the original analog tube so surveyer couldn't check if the antenna worked. This weekend we took a 22" LCD down to test everything out and when I run a channel scan, nothing is...
  17. Team PCBeach

    Vessel View 7 or MFD with VV Link?

    New owner (less than 1 week) of a 2003 360 Sundancer and need to upgrade the electronics. The SC5000 display is hardly visible. Currently the boat has a Lowrance 7 HDS, SC5000, Autopilot and new VHF radio. It appears none of the devices are connected since the VHF doesn't get have position...
Back
Top