Search results

Thanks for the reply. They have the rubber insert: https://www.steelerubber.com/aluminum-frame-screw-track-cover-70-4665-340#70-4665-340 or: https://www.steelerubber.com/stainless-frame-cover-trim-70-4666-340#70-4666-340 Not sure which one I would use but I only need to replace the center front...

Hi all. Looking for some info regarding the windshield screw covers. I have the original foam covers and would like to replace the middle section cover with the same material. The rest is still in good shape but that middle section has shrunk. Is that material still available and what would be...

Looking for OEM aft curtains for 2010 40 DA (with hardtop). Prefer blue. Anyone got a set they'd be willing to part with? Thanks.

Looking for OEM aft curtains for 2010 40 DA (with hardtop). Prefer blue. Thanks

Still have the cover?

Just going to throw this out there but might it be possible to get at it from the engine compartment with the hatch open as far as possible? May be worth a look.

Usually cruise around 3200 RPM. Gives me ~25 MPH IIRC

Hey West 32, '97 with stock 7.4L 340 HP MPIs with stock Borg Warner Velvet Drives, Model 20-01-005, 2.455 to 1 reduction. Last had my props reworked 6/10/20. They are Hytorq Nibrals, 4 blades with a 21" diameter, 24" pitch and a .075" cup. Final values on the diameter are 20.75" and 20.80". Hope...

Did you use the same power and ground wires or run something larger?

I haven't got the old one out yet as it failed and spewed gear lube on the way to winter storage about 3 miles from the marina. I'll know once I get it out. I do like the ones from Hardin though. Don't know why I hadn't come across those in my search. Thanks for the tip!

I need to replace part Mercury Mercruiser Marine - PUMP ASY-SEAWATER (#46-807151A8) (97 7.4L) but I was hoping not to pay over $700. I've found one less than half from a place called The Ropshop. Its a complete assembly and new but manufactured in China. I was just wondering if anyone has used...

I bet it sounds great! I upgraded to a Fusion RA70N and did the same thing as you as far as placement. Just curious if you put the new alpine 5ch where the original Clarion amp was? I'm about to swap to a new amp as well.

Didn't pour coloured water but it is definitely soapy shower water. I dried up the bilge area and let it sit for a few days. It remained dry even after a heavy rainstorm. The AC runs all the time but again it drains into the shower sump and it's not overflowing. I then poured water into one of...

I dried up the bilge area and let it sit for a few days. It remained dry even after a heavy rainstorm. The AC runs all the time but again it drains into the shower sump and it's not overflowing. I then poured water into one of the drains and the water showed up maybe an hour later. I can't even...

The piece of trim appears to be removable. However, I can slide my hand behind it and can feel that the shower stall is all the way to the floor (if that's where you were going with this)

Thanks but I checked the AC pan. Draining as designed into the shower sump box.

Thanks for the reply Brett. Checked the AC pan. There is no water around the outside of the pan. The pan drains into the shower sump as designed.

97 SR 370 EC I have two shower drains. I'm getting water from the shower in the bilge compartment where it doesn't belong. I've eliminated all possible sources of water and isolated the leak to the drains. The sump box does not leak and it's not rain water. So it's either the drain(s) or drain...