Search results

Hi all I sold my boat and have the following spare parts for sale. Onan pressure switch 0309-0717, Onan belt 2375 ,Cummins sensor temperature 4088832, boost sensor 4928593.2 Racor 2010pm filters. Total value $300.00 I will accept any reasonable offer for all.Thanks

Hi all I sold my boat and have the following spare parts for sale. Onan pressure switch 0309-0717, Onan belt 2375 ,Cummins sensor temperature 4088832, boost sensor 4928593.2 Racor 2010pm filters. Total value $300.00 I will accept any reasonable offer for all.Thanks

Had the same issue bad ac pump

My cord was repaired by the previous owner.I believe he dipped it in a plastic coating holding up well.

Thank you for explaining the fuel valve set up. Very much appreciated

I am trying to understand how my fuel tanks are plumbed to the Racor filter. There is a ball valve which feeds the filter and a ball valve that is for fuel return. What is the purpose of the shut off for the return side. Does the existence of a return shut off allow us to choose which tank the...

Thanks for your reply .I greased the fittings and sprayed WD40 on the pistons .This seemed to eliminate the binding noise .I will keep a close watch on this issue. And always use the safety bar.Thanks

No more like groining noise. Going up no noise at all. Sounds like the pistons are binding up. I going to grease the motors and spray lubricant on the pistons. If no improvement I will have to replace the actuators. Thanks

Hi all went into engine room today. I raised the engine hatch all normal going up. When i began to lower the hatch. I heard an unusual loud grinding noise as the hatch went down. Anyone ever had this happen. Thanks

The pump was replaced 8 months ago.It is a large pump the size of a pool pump.Mounted with screws to the engine room bulkhead.

Yes it is more of a vibration.I will try to source out some type of rubber pad to dampen the vibration.Thanks for the advice

Hi all my ac pump mounted on the forward engine room bulkhead is a bit loud for guests sleeping in the aft cabin.Has anyone relocated the pump to a different location in the engine room.Thanks

My port side wiper keeps tripping the breaker.Has anyone removed and replaced the wiper motor.How do you access the motor.Thanks

Villain I believe Tony Athens At Seborn marine sells a replacement system that is compatible to our smart craft system.

What model antenna is on the boat.If it is from 2008 there is a good chance Direct tv is no longer compatible and you will need to upgrade to a new antenna.

Just noticed some corrosion on my water heater.Has anyone replaced their water heater.If so what make and model is a suitable replacement for the original heater.Thanks

Looks great what is the make and model #of the tv Thanks

Can anyone offer up any ideas as to why i keep burning out the bulb in the freezer located in the galley. Thanks

What is the average life span of engine zincs.I found after 6 months the majority of mine.needed replacement.

What is the procedure to clear a fault code on Smart craft vessel view.