So last night on my way home from dinner i am cruising at about 2600rpm. everything is fine. it was such a calm night, i increased my rpm's to about 2800-2900 and i get a high pitch whistle noise. i back the throttle down to 2600 again and it goes away. i tried this a couple times and kept...
looking for some help and hoping someone can point me in the right direction. i have a 2010 450. the moon roof has weatherstripping around it that is pretty dry and starting to crack. i want to replace but not having any luck finding the replacement part. sea ray was unable to help me. on the...
Hey guys, I’m considering a 2012 450 sedan bridge and have never been on one. Anyone local on Lake Saint Clair own one that would be willing to allow me to see??
I’d appreciate it.
Hey Guys. It’s that time of year and I am getting ready to pull out for the winter. I’m storing outside for the first time and wonder if there is anything special I need to do to winterize my pods.
Anyone have a Garmin open array radar GMR 404 XHD or a GMR 18 HD dome sitting around that you would be willing to sell. Mine died and looking for a plug and play replacement.
thanks
Has anyone changed out their old seavision for LED and still have their old control box? Looking to buy one because one of mine has shorted out. Thanks
Anyone else in the Michigan area with pods? Where do you get them serviced? I only know of Colony and Bayview Yacht crafters. I’m looking for another option.
Hey guys. Wonder if someone can help me with this. Here is what I’m experiencing on my port side. Let me preface this by saying this is on a 2010 450 sundancer with Cummins 4800 and Zeus pods.
port side…..
-Intake temp higher 10 degrees
-Boost psi is higher by 1.5psi
-Gear pressure higher by 8...
Wonder if anyone can help me out. On my 2010 450 with Zeus pod, my auto trim tabs are working somewhat as they should. Meaning, they are definitely moving around as I’m cruising and keep me mostly flat however I seem to list just a bit to the port side while under way. I know they are working so...
I’m sure it is something easy but on my 2010 450 I cannot get the floor lights (courtesy) to work. All other lights work just not those small ones on the floor. There are I think 9 of them and I’m sure no way they are all burnt out being LED. The switch by the aft door does not seem to do...
So I have a friend who just purchased a 2006 38 sundancer with 8.1s HO’s. The problem he is having is that he is not able to get his port motor above 3200 rpm’s. The weird pet is that while underway sometimes it starts to reduce to 3000,2900, Down to 2600 rpms. Also sporadically he will lose all...
Any help guys? I noticed oil at the base of my pod. Everything seems normal, boat runs fine, gauges look ok. I had both power steering actuator seals replaced recently and the shaft seals done at same time. The mechanic did notice some scoring on the shaft but said he thought I’d get a couple...
Hey guys need some help. I’m helping a friend with a 2006 38 sundancer. His state room door has come off the tracks and the sliders fell off the track and in the back. How do you remove the door??
Coming across the lake today and got two error codes. Came to port and docked safely but when below the engine hatch found hydraulic oil dripping down white bottle. After letting it cool dow I took the lid off and found the level to be at the very top. Any ideals?
Coming across the lake today I got a message about my trim tab. Then get these error messages. Pull into dock and go into the bilge to find oil leaking everywhere. When I open the cap it is filled to the top... not sure what this is