No water in bilge. Only one bilge pump.
A little research and it looks like the other unit in the bilge is the trim pump...Maybe I need to check the level in it? Does it have a sensor/alarm?
The reservoir at the front of my engine has been topped off and is ok. I also have another small reservoir of some sort in one of those rear side compartments...I don't even know what that is. I guess I need to figure that out.
Often times, when pulling someone on a tube and starting from a stop, the alarm will go off...I can back off the throttle, then throttle back up and it will stop. Any ideas what this is?
I thought the oil level was low, topped it off, but it still does it.
I began having problems again last year, and now, it isn't working at all..doesn't matter if the remote has a battery or not. The head still has power and shows the time, but will do nothing else.
Time for a new radio!
I cut the connector off the fan and used jumpers from the boat harness to the bare wires of the fan...still nothing. I moved the negative jumper from the boat harness to the boat battery...still nothing.
Measuring the ends of the two jumpers when coming from the boat harness, I measure...
I cut the connector off the fan and used jumpers from the boat harness to the bare wires of the fan...still nothing. I moved the negative jumper from the boat harness to the boat battery...still nothing.
Measuring the ends of the two jumpers when coming from the boat harness, I measure...
When I am checking the harness connector, I am using my meter and sticking the black probe into the negative side and the other into the positive and getting almost 12v...that doesn't indicate a good ground?
I played with it some more and all I get is a real low hum from the fan that I can barely hear...that is with it plugged in using the connector.
Is it possible for the connector to go bad? It gets full power and runs fine when wired from the battery to the fan connector.
I have wiggled, pulled, and pushed on all the wiring and connectors...all seem solid and the fan never would kick on when doing so.
Switch should be good since I have power to the end of the harness.
I think my only other option is to cut loose the ties holding the harness up, cutting off the...
I posted this in the Sport Boats forum but wanted to post here also...hope that is ok!
The bilge blower on my boat is not working at all. I pulled the blower, rigged up a couple wires off my battery and when I touch the terminals in the end of the connector, the fan works.
I used a meter and...