The headliner is easily removed using a Phillips- Head screwdriver and "feeling" for the screws along the forward edge. Once you find the screws you create a "hook" out of a flat piece of metal and grab the liner and peel it back thereby exposing the screws (I used on of those metal covers for...
Does anyone know what that sensor is on the very end of a V-Drive transmission (the forward end) it has two leads with connectors and they have both broken off. I need to replace that sensor. Any Ideas on where to get the part?
This is the best I have:
http://clubsearay.com/showthread.php/10364-Official-%281998-2002%29-310-Sundancer-Thread?p=471273&highlight=trim+tabs#post471273
cushions back in .. 4" memory foam (that will level to the "Lip") then a nice big comforter ... and 4 pillows to cover it when not sleeping.
You will sleep wonderfully... I have not yet found a c-channel trim to fit over the lip edge.
Here is the finished picture of everything above...
there were a few posts earlier in this thread how to do that .. i think I replied to it.. Found it:
copied to here:
The head liner must come out to replace it. Feel for screws along the edge maybe about 3/4 - 1 inch from the edge and make a "fabric grabber" (long thin piece of metal with a...
Tides Marine - Strong Seal (makers of the dripless shaft seals on our v-drive models) has a rebate program. If you contact them and ask them to send you a replacement, they will give you a RMA - MRA number to return the old, bad one and you will receive 1/2 of the purchase price back as a...
I would suggest the SL70C if you can get your hands on one unless you need the dual station functionality. it fits in the same hole if that is your goal. It's color and much faster to switch screens.
Ok so I am now very frustrated... Last year I had to replace the strbd shaft seal. The mechanic had to cut it off and therefore had to replace the shaft as well $$$$$ ... Yesterday the Port seal failed and started leaking. I have the blue dripless seals.
How many of you with the inboards...
Cannot comment on other questions but regarding the label:
I see the "SHIFT" one but http://www.searay-parts.com/Sea-Ray-s/160.htm?searching=Y&sort=13&cat=160&show=240&page=1 do not see the throttle label .. You may try calling them.
Start reading at post 710 .. see if that helps ... I caulked all hatches last year and found that the default installation used a gasket! So that may be the problem. - I'd 4200 all three hatches if I were you. It's easy...
To remove the head liner you have to feel about 3/4 inch from the edge for screw heads. Then dig the "tucked" material out of the crease only around the screw heads. and unscrew the expose screws. I used a computer port cover (you know the little metal plates that cover the unused places where...
Has anyone thought of or has already installed anything like this:
http://www.seadek.com/p-189-sea-ray-310-sundancer.aspx
My swim platform is actually stating to become .. un-textured....
I would recommend the 340... You will get about the same running GPH even with the larger engines.. and MUCH more room. Wish I went with that boat in the beginning.
If you get a horizon engine on the 310 ...
make sure that you check that the water ingestion problems have been fixed and...