He and his girlfriend stopped at our marina last fall for lunch. I believe he said that he was thinking about selling the boat and may even had an offer. I was wondering where he's been.
Jaybeaux
The run from Coinjock, NC to Portsmouth, VA is 50 miles. A real treat is to stay at Tidewater Yacht Marina. There is a pool, restaurant, short walk to a ferry that will take you over to Waterside. The Nauticus Museum is worth the trip. Of course, don't pass up the USS Wisconsin. You can...
My experience when I bought the 48.....Everything that the surveyor identified, I put on a list. My Marina, who was also the broker, estimated the cost to fix each item. The Marina then "gave" me $X,XXX to fix/repair anything that I wanted whether it was on the list or not. The budget they...
I don’t follow what you’re trying to describe? First, the above water port as you call it is essentially a bypass for when you are at idle. The engine is not creating enough exhaust pressure to overcome the pressure created by the boats draft. The underwater exhaust port is torpedo shaped...
@highslice We lived in St. Louis back in the 90's. I loved listening to Jack Buck and Mike Shannon on KMOX. You could always bank on Shannon being sloshed by the 7th inning.
A group of guys in our neighborhood always talked about getting a limo and taking in a Businessman's Lunch Special...
Ok @Blueone is leading this train. The Hyatt at Kent Island, aka Kent Narrows is the venue. October 24-26/27, 2024. At least a Thursday and Friday night stay, with an option of a Saturday night stay for you die hards. You know who you are. @Skybolt is the UNOFFICIAL Master of Ceremonies...
@Skybolt Which hotel should we "base" out of for those arriving by car?
Best Western?
Hyatt Place?
Hilton Garden Inn?
Holiday Inn Express Annapolis East-Kent Island?
Thought it would be fun if the "out-of-towners" were confined to a small area!
Just wanted to bring "closure" to the side-bar thread on wipers. @Shaps that terminal puller worked like a champ! As mentioned previously, 3 of the knurled pieces stayed on the shafts and one came off in the arm. I had to get a bit creative to use the lug puller to "push" the knurled piece...