correct, after a research about the IAC the symptoms don't match, my engine starts right up but stays around 400-450 rpm for few seconds and using the throttle won't do anything.
Even with throttle won't start, temperature was around 80's , I always run the blower before starting and on idle like no wake zones etc, what's the IAC valve? Thanks!
Hello guys! this is my issue. I have a 2007 290 DA with twin 4.3/ Bravo 3, this issue happened to me last summer 1 time and it happened again last week, after everything runs good, sit and a cove for 4-5 hours my starboard engine will start for 5-6 seconds but it won't pass 500 rpm and then...
Thanks for the help! I found the one wire on the fwd EIM (acc1) so that helps me a lot, I did try to find the one on the the aft EIM but i didn't find the wire for acc2 , thanks again for the help!!
Thanks! I will look today, my EIM is right there below the steering wheel, I will look to see if I see the extra wires or connector, also if I remember correctly there is an accessory 1 and acc 2 switch, thanks!
I have a 290DA 07 that the previous owner have the under water lights wired with the bilge lights, I hate that every time I turn them on I know the bilge lights are on for no reason, the question is how to wire the under water light to one of the accessory switch on the helm switch panel, has...
That's why I'm trying to find out, I purchased the boat a little over a year ago, I have a deep cycle battery going bad and apparently it what the starboard engine use to start, I was wondering if previous owner changed it, I do have an onboard gen set thought. Thanks!
Does any one know what's the original set up of the batteries in this boat? Currently I have 1 cranking and 2 deep cycle, I got twins 4.3L set up, any help is greatly appreciate it.
I have a question about the galley fridge in my 07 290 sundancer, what's the replacement model number and if do I need any modifications to replace it, thanks!
Thanks again, I was able to remove it quite easy, to find out the speaker had a cable unplugged, now that know what to do I can upgrade the factory installed Panasonic......
Hello, I need help, I have a 2007 290 and I need help removing the speaker that is located near the cabin entry, I have tried to take the cover/ trim without luck and I didn't want to used a whole lot of force either to prevent breaking anything, that speaker is blown and I would like to replace...