Search results

I have a 1998 400 Sedan Bridge and would like to replace the bridge canvas with a hard top and wanted to know if that boat ever came with a hard top and/or is there companies out there that make them. At this point just trying to find information and even picture of someone else who has done...

On a 1998 400 DB how is the waste level determined, my reading only goes to 1/2 even when full, also is there a over fill line on the top of the tank.

Have a 1998 400 DB and my salon ac unit needs charge added but all the labels are unreadable so wondering if someone knew. Hoping its 134 but not sure, thanks in advance for the help

Has anyone dealt with united marine underwriters for their insurance. I got quotes from 3 companies and they were under the other two by a good amount so wondering if they are on the up and up?

Boat is a 1998 400 sedan bridge with twin 3116 diesels, question is what is the transom constructed of? I thought it was made out of solid fiberglass. Reason for question is was getting a survey done on one and on the short haul it was noticed at the very bottom of the transom it sounded hollow...

Need A wiring diagram for a 1998 400 sedan bridge with 3116 cats, went on searay site and wasn't available, thank you in advance.

Where does everyone get their insurance from? Never had to buy yacht insurance before so new area for me. Also what was your experience with the insurance company? Under cotract for a 400 sedan bridge so covering bases.

I have a question for owners of 37 to 40 foot sedan bridge boats. I am looking at getting one of the above and notice most of the ones available have twin 7.4 motors and was wondering if the boats were under powered verses 8.1 or diesels.Just would like peoples opinions on this, will be doing a...

Anyone have any dealings with the above good or bad, they have a couple of boats listed I might be interested in but the one broker who has them listed will make appointments with me for a video walk thru and then not do it and not call to cancel and not return my calls when I call to find out...

I have a 1995 290 DA and I did a search and nothing came up and I know the part number was posted on here before for rubber piece that holds the screen in the side oval windows on most of the searays. Got two going bad and leaking and need to replace as part of my winter projects, Thank in advance

Looking for a marine surveyor and wondering if anyone on the forum has used one from this area and their thoughts and experience. Thanks in advance.

Did the 2002 320DA with 5.7's come with the problem cool fuel units? Thinking of looking at one and just want to know what to look for.

Checked on searay site and wiring is not in owners manual or any other manuals they offer. Does someone know if there is and where an inline fuse could be for the emergency bilge pump? The main 12 volt breakers on dash are all good but not getting power to emergency bilge pump, regular pump...

Have asked this question to various mechanics and other boat owners and get many different answers, so going to throw it out here. With twin outdrives either alpha or bravo should the drives be parallel, toed in or toed out from each other?

looking for a complete wiring diagram for a 1995 290 sundancer. Been going thru the wiring and finding a lot of wires that are just taped off, some hot some not. Everything is working but like to know where they go too. Thanks in advance!

Have 1995 4.3 v-six engine with 4 barrel carb and had thunderbolt V ignition. On the fuel injected engine you have to ground the purple/white wire to set base timing but was told on carbed engine you don't have to,so is that correct or do you still have to set base timing. the carbed engines...

Just got my 2018 sierra dealer catalog and was checking it out to see what was new and I see they have a 75 and a 125 amp replacement alternators. Didn't look at what engines them fit but guess the are available for most engines. Just thought I'd throw that out there cause I see people asking...

A while back someone posted about a replacement part for the rubber insert that replaces the rubber mount that holds the top to the windshield on searays that you can then put snaps into without drilling the windshield frame. I tried searching past threads but couldn't find it and called...

I have a 29' sundancer with twin 4.3 mercrusier engines and alpha 1 gen II drives. My question is do the drives have to be parallel with each other when straight forward. Mine are off about 5 degrees and asked different people and two different mechanics and get different answers. I would think...