Search results

The bulbs on my energize switches are burnt out, and I would like to replace the bulbs. The switches still work. Does anyone know where I can get replacement bulbs and or part numbers? According to the part manual the switches are. I have a 2005 Sundancer. 681494 BODY, ROCK SW DPDT MOM 12V...

Does anyone know what the cylindrical part of the 8.1s Horizon water pump does? I replaced impeller on starboard engine, re-attached hoses and I can’t get the water shooting out the side of boat, I actually pulled the pump twice (to review my work) as it didn’t work the first time, and it’s not...

This spring while waiting out covid19 I plan on installing a drain plug light and a port side arch mounted 12v Tv on my 2005 Sea Ray 340 Sundancer. I need advise on the how to supply power to these units. 1) where is the best place to connect the TV 12v power wire so power is supplied while on...

I plan on adding a drain plug light on my 2005 340 Sundancer and connecting it to the aft EIM Accy2 which I believe is spare. I realize that the EIM is a very expensive and hard to replace item. Previous posts have indicated caution and or a reluctance to connect to this sensitive module. What...

My 2005 SunDancer is currently under winter shrink wrap. As soon as they open the marina my plan is to change the leaking rudder packing. I want to have the packing in hand but not sure of the rudder shaft diameter. I think it's 1.5". Does anybody know for sure what the shaft diameter is? Thanks

I am considering replacing my arch lights with the Lumitec full color spectrum lights. Adjusting the color and intensity of these light requires frequent pressing of the arch light on the EIM switch panel. Has anybody had experience with these lights using the Sea Ray EIM system? How robust is...

On my 2005 Sea Ray 340 Sundancer I have two deep cell battery banks, 4 batteries total. The batteries in each bank are connected in parallel. I have looked at the schematics but have not determined with any confidence what each battery bank does. I don’t want to leave myself without starting...

I would like ability to dim the cockpit LED lights for night cruising, yet still be able to turn them bright again for dockside cleanup and retarping. There have been many threads here replacing them with different bulbs but my first choice would be to be able to dim them to different intensity...

Our plan is to replace the waterline tape stripes and have the boat buffed and waxed before spring launch. We are concerned that buffing and waxing may damage freshly applied tape and are also concerned that the tape may not adhere properly to a freshly waxed/buffed hull. What is best to do...

I have a 2005 340 Sundancer and would like to make a table/cover for the cockpit sink (to support a blender and other beverages). Any ideas or photos on how to do this would be appreciated. Thanks

I want to get Yeti 45 cooler as a x-mas gift to myself and secure it on the swim platform of my 2005 340 Sundancer. My boat is currently shrink wrapped and in winter storage so it is not accessible until spring. The cooler is roughly 16" high. If secured (tied down) in the center of the swim...

The holding tank is full yet the sensor is not indicating a "full" reading. I have pumped it out a refilled with fresh water and detergent and still it will not indicate a "full" reading. I now suspect I will have to remove the sensor (ugh) for a good cleaning and to verify that it is working...

I recently purchased a 2005 340 Sundancer with twin 8.1l engines, v-drives and am trying to familiarize myself with information the SC1000 smartcraft system gauges can provide and I have a couple of questions. 1) both tach's will display RPM information. Should I not have "RPM Synchronizer" as...

I just purchased a 2005 340 Sundancer. The cockpit passenger dash has a chip and some small cracks? Can anyone recommend a product and method used to make this repair?. The name and brand of paint to match would also be of great help. Thank you.