After installing Vessel View Mobile, I show a Level Sensor Tank B Fault that popped up. The Port Fuel guage on Smart Craft guage shows fuel level movement when I gas up. I'm seeking any info/help on where it is located, what it looks like and advice on addressing this sensor fault? Boat is a...
I purchased my new FC3 from local dealer for $1225. The re-install was a breeze (be sure to get Loctite 567 for elbow thread and add fuel (@1.5") to chamber and (1") to the filter cup at install to prime) Upon removal of both filters, I found at the base of CF3, it was sediment and paint...
All good with NEW Cool Fuel Module 3 installed. Used Loctite 567 on threads of fuel inlet "elbow" fitting already installed on CF3 at inlet. Inserted pump power wire into harness. Powered up helm ignition switch. Primed the NEW CF3 1/4 way up filter chamber, added fuel in cup for filter, just...
The new CF3 is installed on Port engine. Needed Loctite 567, no locals had it. Amazon to the rescue. Must use 567 on elbow threads on brass fitting from inlet fitting to CF3. Must prime filter chamber, key on, prime pump 3x, repeat both steps 3x. Check for good spray "up" at Schrader. If spray...
The low pressure pump is bad. But the now problem is a pump housing Stud broke off in the body. Tried drilling it out and using an extractor. That attempt failed when the extractor broke off in the hole. This fuel cooler is one of the painted one's. I've got a new one on its way. I've now Got a...
To all my SR Friends. I found the scraper ring had torn slightly. With a replacement installed, and fresh fuel in the filter chamber, I was able to get the engine to run @ 3 minutes. With no fuel from the tank to the chamber, I took off the fuel supply side and found no suction when activating...
My 2007 searay Sundancer was due for routine maintenance. All went well on both 8.1 engines, changing plugs, changed the starboard sea water pump, engine oil, all done the week before. At that time, both engines fired up, all checks we're done and both engines ran fine. Last week, I replaced...
My combo mast front light, stopped working. The rear bulb is on w/anchor but no longer comes on with the nav/anchor lights. Bulb is good. Got 12v at each bulb when anchor button is pressed, back light on but front is out. When I press nav, R/G is on but neither mast light comes on. The stern...
I had same ec62 code that was hard to identify the root cause. The generator would run, but only for a short time, i'm talking minutes. After keeping fuel lines away from hot items (used wood shims) I was able to determine it was a fuel issue as The generator now ran 4-5 minutes. The fuel was...