It is only a 3/4” thru hull that sandwich mounts (no screws)and would not have left enough threads for the ball valve to thread on if I went thru the thicker pad, the glass was 3/4” thick where I went thru, so plenty strong but I understand what your saying.
I ended up installing it under the sink at the galley.Had to pull the refrigerator out and both bulkheads on each side of the fridge also had to make a floor for it to sit on. I used a Webasto 6000 unit and it does a great job, it was a lot of work but worth it in the end.
Thank you for your response, already checked. Out the under v-bunk (not deep enough) but the mid cabin location sounds promising, I’ll pull that panel and see what’s behind it.
Yes, all portlights and front hatch were removed and rebeded, they all leaked, also repaired screens at same time. The dated green and gold color stripes and canvas have been replaced along with the rear seat and a few of the other cushions also. The boat had sat for 5 years in less than...
Hi All, Thought I would share some pics of my 1998 250DA project boat, always a work in progress but essentially finished it this spring and I have to say came out great.