I was tired of the crazy quotes I was getting so I started my own biz doing these. I get the LEDs, controller and remote control (off the shelf), fabricate the letters in either the 3D style like what you see on Sea Remedy, or for less cost - the low profile which is just sheet stainless over...
Just installed my stainless LED backlit boat name.... 316 stainless, UL/CE certified, remote control, RGB LEDs. Not for everyone, but I like the little extra uniqueness it allows. RGB LEDs allow for any color you wish... now I can match the color I choose for my underwater lights!
After a trip to Shelter Island, LI from Niantic, I noticed something amiss. Turns out I had both shafts wrapped with what appears to be lobster pot line. While there are lots of pots around Plum Gut and on the way, we keep meticulous look out to avoid them so not sure how it happened but it...
‘97 400 DA with 3116TAs. Seems I am in need of two fuel sending units. One was replaced a couple years ago with the Universal one from Flounder Pounder but only reads from empty to half full. The other (port) seems to have stopped working altogether. Replaced the gauge hoping that was it but...
Thanks to Riptide III (Phil) for his expert skill and craftsmanship - installing a new floor in my 1997 Sea Ray 400 Sundancer . And thanks to Sandi for letting me borrow him for a week to do the job!
Thanks! It looks just like JVM225 above but instead of all the lights lit up, my 3/4 lights up when I push the button along with whatever the real level is at (empty, 1/4, 1/2 or full).
happy to pay for your time to fix and test it!! Thank you!!
Hi Jim- have a 1997 Sea Ray 400 DA where that fresh water tank LED display lights up the 3/4 light no matter the level of the tank. Empty is empty and 3/4, half is half and 3/4, etc. something that can be fixed? From your posts you seem to be the expert on these things! Thanks!! John
Hi Jim, I am in Niantic and have a 1997 Sea Ray 400DA that I would like to replace the interior carpeting (awful green color). Saw the thread and am looking for installers in the area. Can you connect me with your installer? I winter the boat indoors at Petzold's in Portland, not sure if they...
Anyone try welding it? Did it work? Just noticed my aft cabin floor wet after I filled my fresh water tank to spend a week on a mooring. What about Flex Seal? :-). Don’t really want to replace this thing if I can fix it.
Have a '97 400DA with 3116TAs - my zincs were gone when I pulled the boat, anyone know where the galvanic isolator(s) may be located on the boat? Figured I should start there to try to see if they are still working or not. Thanks!!
John
Just hauled and my trim tab and main transom zincs are entirely gone except for the mounting bolts. My dock neighbors were fine. Any idea what would cause this or where I should start to look?
Thanks!
97 400 DA
I have a Lewmar windlass with an 002 gypsy which takes 3/8”. I am about 20 minutes from Defender so that is what I will do. They have some nice “scratch and dent” stainless lewmar anchors very low price. I just bought one. $1400 anchor for $500.