Search results

Has anyone read this book? I just got it and I've only read the forward but just the forward is enough to make you just shake your head at how it's possible that this guy is still allowed to be in change of ANYTHING.

Sorry for another vacuflush thread but I couldn't find anything on this particular problem. When I flush and release the pedal the fresh water fill will not stop running. It has done this sporadically over the past year and a half but today it finally won't stop at all. Any idea what part I need...

My westerbeke 7.0BCGB ran great the day of launch as we had no shore power I let it run for an hour or so to charge up the batteries. We changed the cap and rotor over the winter and it was actually running smoother than ever. Came back a couple of days later and since then it runs for 18-20...

Is there such a thing as a rod holder motor mount for a dingy motor? I would rather not permanently mount something on the transom.

I just updated my electronics to a 12" Axiom and a 7" Axiom and my plan all along was to be able to integrate my engine data on those units. I had a tech do the installation and we have been unable to get the connection to work and before I call the gateway a bad unit and return I just want to...

Hi all, I am looking to replace my dead cockpit ice maker with a Fridge. However I am not interested in a AC/DC model so I am curious if anyone has just put in a low cost 120V dorm fridge. My feeling is that even if it rusts out in 3 years and I replace again I am ahead of the game and I really...

My engine hatch actuator often struggles to open the hatch. At first I thought it might be weak batteries but I load tested the batteries and they are fully charged and functioning. Some days it works fine and other days not so much. If someone "assists" it then it comes right up and the...

I need a replacement Masthead/Anchor light for a 2003 380DA. The SR part number is 1543750 and the actual Perko # is 1123SPL004 which of course was a special order from Sea Ray. Sea Ray does not have any and Perko has nothing close. This is the light with the double bend which I know is on at...

One of my drawer knobs stripped out and I was wondering where people get replacements. I ordered some from Flounder Pounder but they do not work on the drawers because of the thickness. The old one has an extender sleeve as seen in the picture which is what stripped. The new one from FP is...

I have an RL80C which gets it's GPS signal from a Raymarine RN300. The RN300 has a fix and yet the RL80C tells me no fix and thus no chart navigation. This happened when I first got the boat and suddenly fixed itself so I paid no more attention to it. The infection is back again so I wanted to...

In my new to me 380 my Westerbeke generator is surging. Not terribly but not normal either. It does it with and without load. I have changed the fuel/ water separator (it was completely clean). When I hold down the preheat switch the surging stops. When I release it starts again. The generator...

On my new to me 2003 380DA equipped with an RL80C I am trying to change the chart plotter orientation to "Head-up" but the unit is not allowing me to do so. When in chart setup mode, the soft keys appear but it doesn't allow me to select head-up. I can choose either north up or course up with no...

On my new to me 380 the props are two different pitches....starboard is 22.5 and port is 23. At Sea Trial, the stbd engine turned up higher as would be expected. In going through the old paperwork from the prior owner I see that he had the props tuned in 2015 and the report shows that they were...