Search results

Thanks! It’s holding up just fine!

Hey there- we have an 02 360 DA. Love it. Started looking at mid to high 20 something towables, then onto several 320 DAs - then onward to 340, 370, 380 and up a few. I came back down to reality and stayed with my 360 search. The 360 was hard to find with 8.1s - a must for me as I can’t put up...

Got it. Thanks!

I like this idea! What’s a pinch valve? Will give it a shot and report in.

Thanks again. I think the one that cracked must have been OEM. You’ve talked me into no stainless. Makes sense and blends in too!

Just saw the pic!

Just caught this when replying. Wow! It’s not stainless! Thank you.

Good idea! Would love to see what the OEM hardware looks like.

Appreciate it! That’s correct. I hope it holds up too. The material for the 3D printer happened to be very close to DA white! Stainless would be ideal. If you get a sec, could you post a pic of what you have?

TGIF - Does anyone know where to get OEM (or other) transom door stainless sliding latch receiver hardware? The part doesn’t appear on the original 360 DA spec/schematic. I’m not sure if the previous vessel owner made the one that was installed…but it cracked (was not stainless). I replaced it...

Fixed pic so you can read it now! Thanks.

Will do! Thanks much.

Thanks for the tip! Good idea. If that doesn’t work, are you aware of a good replacement freezer or convertible unit (freezer or fridge combo)?

Hey All - getting ready for a new boating season and finally decided it’s time to either replace or get the Coolmatic RPF 50 original 360 DA OEM freezer fixed. It runs but doesn’t do anything. I haven’t been able to find out here what folks have replaced it with (want to use the OEM insert/cover...

Great advice - I had the hatch open the week before - do the same checks before heading out. It’s been quite dry here and quickly got humid with lots of rain, so maybe that contributed to the stickiness of the seal? I’m planning on replacing it this winter if I can find a good solution. I like...

Joined CSR when looking for our first boat - so many helpful replies to my questions. Thanks again everyone! Since then, we've been loving our 2002 360 DA...and glad to be a part of this resource! Take care.

I received some comments on another are of this site, so here's the same info here for this forum section... Update: I was able to open the hatch last night - toggled the switch (open and close) about 100+ times and it finally gave way. First, I checked the magnet idea on the transom door -...

Update: I was able to open the hatch last night - toggled the switch (open and close) about 100+ times and it finally gave way. First, I checked the magnet idea on the transom door - I've seen varying comments about DA's here with or without this safety feature. I don't think my 360 has it...

Thanks! We’re going to try and see if that works. What was the issue with your hatch after you got it manually lifted?

Thanks - we’ll give that a try. Everything else DC works shore power is live/working.