I’ll check it. Pretty sure my gen isn’t connected to the co detector in the cabin since the gen was new installed after the original threw a rod. Worth a check and look.
I have a 2008 Amberjack 290, with Westerbeke 5.0 MCG-614 WHT GAS GENSET. Had the generator put in brand new in 2014. Currently, I can't get it to start. The engine will start to crank when I press start. The engine turns over a few times and then stops, check engine light shows. I can shoot...
Make sure the through hull valve is open so the generator can pull water through to cool. There is also a sensor that detects water flow through the generator that can get corroded and stay in a closed position so the generator doesn’t know water is flowing. You can replace that very cheaply.
Great Lakes Boat Top Company is online and makes replacement tops. You can email them on their website and get a quote. I got an email from them recently that was advertising 20% off. The company makes tops for lots of boats and will be a little on the pricey side, but they will give you a...
I’m going to do this as well because I think my sump needs some TLC. The float switch sticks, but the bulge is collecting water even with the water tank empty and not running facet or shower.
Thanks, that's pretty much going to be my next step. I'm curious if there are any usual culprits as a point of entry from the rain. I wonder if the water is coming through the deck where the opening is for adding water to the water tank. That area looks good, but I may need to try some...
2008 Amberjack 290. I keep my boat in a lift out of the water. There is a bilge compartment under the mid birth where the shower/sink sump pump is located. Within the bilge is also my water tank. I keep virtually no water in the water tank when my boat is in the lift. I have noticed that...