Hello all. Here is what I have going on. 1985 sundancer 300 with merc 260’s. For the first 1 1/2 hours the boat performs awesome at any throttle position. Then after 1 1/2 hours of continuous running, mostly cruising at 3200-3400 rpm’s the boat suddenly drops down to 3000 rpm’s on the...
I have installed a lot of Formica back in the day. I would not use anything other than contact cement, If that were me, I would get a heat gun and heat the area back and forth, then use a large drywall knife 8”-10” and slide it as far under the area that you can. Take a couple of wooden dowels...
People seem to forget that when they are in a hurry, somehow we forget to put the vehicle in park! Back up, hurry up to get launched, leave vehicle in reverse or forward. Seen it happen before at launch sites. lol
Not sure if this is the right place to post this, but figured I would get a bigger response here. So, my question is this: I have a 1985 sundancer 300 with stock aluminum 14x19 propellers. The boat is a dog out of the hole, I always have to use tabs to plane off. I have read on here that...
I’m thinking about asking the Clintons the best way. It’s the most effective way I’ve seen. Wait...... not seen. Sorry, couldn’t resist, I am wondering the same thing, I’ve accumulated a few myself.
Hi Mike, I installed a lewmar v700, bought all my equipment from Darkhorse Marine from Clearwater Florida, after talking to many companies, I found that Bobby from Darkhorse was very knowledgeable and as we talked more on the phone we actually knew each other from way back! There are many...
I just did a windlass myself on my 300 sundancer last week, it is a 1985 model. My total cost with 150’ of chain, windlass, starboard, stainless steel bolts,anchor, and 100’ of #6 gauge wire ran me just under $1500.00. I’m a licensed contractor so I did not need the necessary tools...