Search results

I agree that could be just a failed pump. I will let you know once I open the pump side to say if its a CF III issue...

Just spent the past week dealing with this issue. Thanks to all the comments on here I was able to diagnose my issue quickly. Port engine shut off on me abruptly. I could not get her to start. Got back on one engine to the marina and did some research. Tested the unit and it was not getting any...

Update On CGIII I tried the schrader valve on bypass and no go unfortunately. I tested power to the pump and it was not getting any. Checked the relays and one had a burnt contact. Replaced that and still no go..Finally I replaced the entire pump and PRESTO! Seems the pump likely also fried...

Any luck finding this part online, or another replacement part? Found a few on ebay for 200..

I am about 100 hours since my last service. So I will try the bypass valve first and if that resolves the issue I know I have a faulty one. Will need to change the fuel filters anyway for service. I leave the oil change up to the marina lol. Will report back ty!

Is this the electric fuel valve? Sorry new to this, I am looking in the diagrams for it.

Hey All, Lost and engine abruptly while planning this weekend about 3800 rpm (port). Engines have been running smoothly and serviced regularly. I was unable to turn over the engine for more than a second. Seems like gas starvation, so with a little bit of searching I found out about the...

I am having similar issues. My port engines is always more full than my starboard side. I believe its a sensor issue, they usually take about the same amount when I refuel. On the gauges it says my starboard side is always 1/4 below port side.

I am having the same issue on my 2006 320. Outcome with yours?

The new helm comes with ORB fittings and the old with NPT. You will likely need an adapter to make the connections. The old Seastars had NPT ports, the new helms are ORB-5 ports. You will likely need adapter fittings. Let me know how it works out. Sea Star KIT FITTING ORB-5 MALE TO 1/4 NPT...

Thank you! Did you need ORB to NPT adapters? (male to female)

Did you have any resolution to this? What did you replace it with? I need to replace mine this week. No significant leak based on the fluids, but air entering from bad seal. Hard to turn the wheel and makes a squeaking noise when I do to either port or star. Going to replace the whole hydraulic...

Remember to apply some silicone on the base of the new switch. Be careful of those wires they dont give much play, I attached one to the new switch and then took off the other.

Having my helm replaced on my 320. Looking to get autopilot placed when she is on the hard this winter. Any suggestions on autopilots?

012374 MAXW SS COVERED FOOTSWITCH

Haha, I have some on my Go Pro. I will be back out there Saturday will upload.

Installed them. No issue at all fits perfect. Used same holes. Just make sure to keep a hand on those wires, they are short and if you lose them in the hull it will be an issue. Don't forget some silicone on the base for a good seal. Happy Boating!

I like the setup. I just ordered Magna Catalina with the shelf and stand for the swim platform. We plan to do a lot of anchoring overnights, make its easier to have a BBQ. :)

Pier 281. Good advice, thank you!

Anyone have some grill setups they can suggest for my 2006 320? Average fam of 4.