I guess the last is my problem. I try to select other pages with the mode selector, but trim always override the display. Could of course try to turn trim off in the Cal 1 setup. It does not show any actual trim numbers. Trim 0-10 or 25 are not present, and that may be because of faulty trim sender.
I have read a lot about trim fault warnings jamming out the Smartcraft instrument. The right way of solving the problem is probably to change the trim sender on the outdrive, alternatively to re calibrate the SC trim setting. Is it a way to get rid of the warning without doing the above...
Thanks. I just bought the boat, and didn’t get to familiar with it prior to winterizing. Just got curious when it didn’t have the typical transducer installed on the rear section. Did not get the ocean temp indicated on the smartcraft, and figured out it was missing. In case my boat got a...
I have a Sea Ray 2300 select 2009, with 350 Magnum and bravo 2 outdrive. I cannot find any ocean temp or depth reading on my smartcraft guage. I have no transducer mounted outside, and wonder if there are other sources that can sense ocean temp and depth and feed the smartcraft guage? Any with...