Hi all,
I had to pull back drive housing (about 2 inches) from the bell housing to check if my water inlet hose was collapsed and now I noticed this. I get a little bit of brown oil/lube pooling in this spot, not much maybe a few drops over a couple of days. I had the drive resealed less than...
Looks like I'm gonna go with a thru hull pick up and bypass the transom hose altogether. Any tips before I attempt the install? Also, what size of hose/thru hull should I use? Think I read somewhere that 1 1/4" is the way to go?
TIA
Bad sensor or clogged intake or......? The reading doesn't budge at all, stays at 40PSI all the time, even at idle. Other engine reads 22-26 PSI at 4000RPM. I'm getting no warning beeps either. If the sensor was bad, would it beep?
And where can I find the sensor??
TIA
Can someone verify that my batteries are set up properly. I recently bought the boat and I have 2 starting and 1 house. When facing the engine compartment to the aft, the current set up is a starting on the left, house in the middle, and starting on the right. Is this correct?
I also want to...
Hi guys
I need to change out my water pump and had a really stupid question. When I remove the hoses at the back of the pump, will there be a constant stream of water coming from the inlet hose since the boat is in the water? I know whatever water is in the system will drain out but do I need...
I recently got mine done plus my sterndrives and as I didn't have any bottom paint before. These guys I went to did an incredible job....sanded, prepped and 3 coats of primer plus 2 top coats of anti-foul using top of the line products for $3K. Fibertech Fabricators in Hollywood. Super nice...
Yes, it's smartcraft. I'd go through SeaRay if I have no other option. I checked their website but no link for parts so I guess I'll need to go through a dealer?