Looking to purchase a Sea Ray with CAT C12 engines. What is the general thoughts about these engine? I know that Caterpillar had some issues with the 3196, and the C12 is the updated version of the 3196.
For starters, I did a full service on the generator in February 2020. Filter, cap, rotor, plugs, filter, anode, impeller, belts, etc. The generator runs amazing, but the past 3 outings I have had an issue. Same route for starting the generator, but shortly afterwards it shuts down within 1...
Just curious as to what others thought about my invoice. 2001 Sea Ray 380, with 8.1’s. Bottom was completely sanded, blisters repaired, tuneup on engines, generator, new anodes, etc... How do the prices look, labor, etc. Please critique.
Wife would like to add underwater light to our 380 while it is dry docked getting barrier paint, bottom paint, props tuned, new striping, complete tune up, buffed, waxed, etc. She wants something super bright, good quality, and dependable. Through hull or mounted to trim tabs? How many lights...
Has anyone updated their Sea Ray Logo’s to give a more modern look? I am thinking about doing something like this.. Top line stripe color would be two black lines, identical size/length as the originals. The water line would also be copied in black. My canopy is also black.
What is the best way to remove these and fill in the hole behind. We have decided to leave the deck without carpet, and i’m not completely sold on any other products yet. The bare deck cleans up so easily and dries very quickly too. With 4 kids, it’s just a lot of foot traffic to clean after.
I have a 2001 Sea Ray 380, and would like to get the bottom painted. Does anyone know or can recommend someone in North Alabama? We keep our boat at the Riverwalk Marina in Decatur.
Finally reinstalled my radar after transporting. Worked before, but it’s not working now. The cable was cut before my 380DA was transported. I rewired everything back to the best of my knowledge, and based on pictures of schematics. The radar will rotate freely when the power switch is in the...
I can not 100% which latch I have? I can’t seem to identify the correct cod number. Please help. The measurements are from edge to edge of the latch, and the thickness of the door. There are so many different model numbers, and I have confused myself.
I’m looking for a smaller round cockpit table for my 2001 380 DA. I believe I have seen a stock smaller round table, but can’t seem to locate one, or the model/year they were available. I would prefer the white composite table. The kids can’t scratch or damage it!! Haha.
I’m going to replace the starboard fuel fill line, and the only way to access one end of the fuel line is through the hull bilge vent on the outside of the boat. What would be the best or recommended sealant to calk/reseal the vent?
New 12’ fuel lines arrived yesterday, and I will be installing tomorrow. Quick question. It looks like I will need to unscrew the outer stainless mount, and feed/thread the new fuel line in that direction. By the looks of it, I can not reach the hose clamps from inside the engine compartment...
The 380 decal on the rear of my boat needs to be replaced. Can someone point me in the right place? Where can I purchase the large blue oval SeaRay Yachts logo?