Search results

So here is where I am... My boat has Raymarine Axiom MFDs on a SeatalkNG network. I have Yacht Devices gateways on each engine, so I have lome limited engine data on the network (N2K). I also have Bennett AutoTrim with N2K output. Of course the Axiom will not display the trim tabs correctly...

Thanks for much for your quick reply. I am finding there is nothing standard about the NMEA 2000 standard.

Do any of the three allow you to configure devices, ie: instance, name, offset, etc?

Anyone have a Lowrance LMF-200 they would sell? I need one for a project.

Mobella Key, Day Key, Orcas, Southco, Replacement Boat Keys (searay-parts.com)

Thank you

Old thread, I know, but..... Who cars about the grill? Where did you get that rail mount table?? :)

I am listing my 1996 290 with new dash and gauges, new canvas, and complete new vinyl...in NC. The listing is not going live until the weekend. Just had EVERYTHING SERVICED.

You are one of the guys I was talking about in my previous post: "I have a bulkhead slip. When other boats come down the fairway, pass their slip to about midships and then back right in, I think, "I wish I had it that easy"."

Hmm...I'm in North Carolina too, with a bulkhead slip, and a finger on both sides of me.

It can be tricky if the weather is not cooperating. Especially with a single engine like mine.

I have a bulkhead slip. When other boats come down the fairway, pass their slip to about midships and then back right in, I think, "I wish I had it that easy".

Engine room fire suppression system status.

LOL! I was :) Now I'm just a guy who need a new dash LOL

Very nice! If I were you, I would make two....just in case. LOL

From an electrical engineering point of view, not an electrician...very different: Fuel sending units work by resisting the potential of ground. Aluminum does not act as a diode. Positive voltages seek ground traveling the path of least resistance. Survey says: Fake News

I had a piece molded out of starboard, then padded and vinyl wrapped. The shape is good, but the vinyl is too loose and puffy. I would prefer something more solid.

hmmm... don't throw away your mold/jig. :)

So....what are you going to do for the dashpad? :)

Fuel pump straight to the bilge?