Search results

Thanks. Turns out it was metric

I have an SD 200 and the nuts fell off my latch that secures the anchor hatch. Bought 5/16 nuts to replace them, but they don’t thread on. Any ideas? iOS it metric? 3/8? Am I missing something?

Brought it to a mechanic and had it checked out. Getting better power and speed. Wasn’t trimmed properly. 4400 rpm 37 mph

Thanks. I am in CT and Marinas are three weeks out. I do have vessel view. Is there a reading in there that might might give me clue?

I i did change the fuel filter and have put two tanks of new gas in it. Maybe I will have get a tune up.

I had the same question about my 2006 with a Clarion CMD4. I saw on another site that the connector cable for my remote looks the same but has 6 pins instead of the 8 on the newer model. You may need to buy a new remote on top of the new deck.

i just bought a 2006 Sundeck 200 with a 4.3 MPI engine. I put a new prop (14.25 and 17 degrees) on it. It has very little power out of the hole and takes a while to plane. It tops out at 4,100 RPMs and only 28 mph. The engine only has 153 hours on it. It is disappointing. Is there anything I...