Search results

Not sure… I just sent a request for more information. Will let you know what I find out.

We put aquamarine mat throughout the entire boat, but now I am kinda of regretting it as it seems difficult to keep clean and in certain places I can see the flooring through some of the gaps. In hindsight I should’ve gone with Nautikflor

Does anyone have the diagram for which way the duckbills are supposed to go? I replaced them and the toilet bowl seal. That worked for a few days, then it started cycling again every 15-20 minutes. My next step was to replace the bellow, but I was so sidetracked that I forgot to pay attention...

I flush my engines out with fresh water every time I use the boat, so I typically leave them closed, but have two laminated card that reads “seacocks closed.” One sits at the Helm and one sits in the panel to serve as a reminder. The AC and Gen stay open.

I did all 4 of the duckbills - where are the bellows located?

I get it.. just surprised... but not surprised I guess. Ha.

I noticed mine doing that over the weekend... I sprayed some W-40, which helped a little... is the recommendation to completely replace the wheel? Seems like there is more to this than just a squeak that needs some lubricant

I replaced mine over the weekends, but did not do the o-rings, nor did I grease them when putting in the new duckbills. Prior to replacing, the water had drained out of the bowl a couple of times, but now it seems to hold water. The issue is that the vacuum still runs every 5-10 minutes. What...

Are you guys referring to the steering wheel squeaking when turning?

Headed back tomorrow with the wet vac to see what I can find. I’m on the Jersey Shore and we’ve had a lot of rain and wind a few weeks ago and I haven’t looked at the bilge since I put it back in the water

That’s kind of what I was thinking as well. Bellows and seals on dripless drive shafts were done in 2016. Wonder if they may be the cause or rudders?

How much water would one normally find in the bilge? We got the boat towards the end of last summer and I don’t ever recall having this much water there. We splashed the boat in early April and ran it once over to the new marina. I wouldn’t expected the pump to turn on automatically. Appreciate...

Did you at least get a good deal on the boat?

How often do you need to replace the drive shaft seals? PO says they were done on my boat in 2016.

Thx!

Any chance you have a link?

Anyone have a good recommendation for a replacement of the galley faucet?

Curious what would be a good alternative for a replacement

Correct but no pressure either way. I’d say you’re right. On my way to the plumbing store now with faucet in hand

Trying to figure out how to get inside of it now.... it’s a Grohe sink faucet.