Hey guys - I know this is an old thread, but I've been following. I have a 06 340 with same issue and thinking about at some point doing the FP solution. In the meantime I'm hoping that nav lights are operational when needed and thinking about backup solutions to use in a pinch. I think...
Uggh! I've been checking it wrong. I just bought the boat this year and plan on changing this fluid/filter here before the off-season but this is helpful - thanks a lot for the response!
This may be a dumb question, but the ZF repair manual seems to indicate for my transmission with a threaded dipstick you check the oil with the dipstick resting in the housing vs fully threaded into the hole. Excerpt of the Repair manual page attached. Am I reading this correctly, you just...
One appears to be DOA and the other will work, but contacts are very sensitive for some reason. If I rotate the new bulb in the contact clips it will light up. No corrosion on contacts so wouldn't think connection should be this sensitive. The standard bulb lights up in same fixture with no...
Bought new 12v 1w festoon replacement bulbs for Perco cockpit lights 12v 10w. The lights work in one of three of the fixtures. Old bulbs work in all fixtures. Any suggestions on troubleshooting?
Thanks for all the advice - Something you may know, but found grainger.com has a lot of marine grade stainless worm gear clamps that are a lot cheaper than marine stores. You can get 10 clamps for the price of 1 at the local marine supply...
Yeah, I should have tried the carb cleaner bit when trying to take it off. Problem is these darn hoses are in the back of the bilge area and it takes me 10 minutes to get in and out (small exaggeration), Need a helper when doing these tasks so I can direct them to grab tools and supplies and...
Any advice on how to make the barbed fittings to the hose easier. Replacing the wire reinforced hoses to my AC raw water intake. Getting these lines off the barbed fittings wasn't easy, I suspect putting them back on won't be a treat either.
I have some boot lube I use for water ski boots...
Any advice on how to make the barbed fittings to the hose easier. Getting these lines off the barbed fittings wasn't easy, I suspect putting them back on won't be a treat either.
I have some boot lube I use for water ski boots that I'm thinking may help, but also heard that you can heat the...
Hello - Wonder if anyone knows if the hose from West Marine SHIELDS RUBBER–Series 135 Heavy-Duty water hose is suitable for AC raw water intake? 200 PSI -40 Degrees to 212 Degrees F. This goes on a 2006 340 Sundancer. Same hose goes from the strainer to the water pump. Pics attached. The...