I had the same issue and even had it come off without knowing, so I had to have the boat pulled to make a temporary repair. I had a survey done as well that showed no issues what so ever. I will be placing a new one on this winter. From what Im told these are designed to come off in the event...
I have to replace an underwater exhaust elbow on my 1995 330 Sundancer. Has anyone replaces on of these? if so, are there any tips to doing so ? are there any gaskets between the hull fitting and the brass exhaust ? do you use silicon or 4200 for sealant ? Thanks in advance for any advice
Im currently on a boat trip and pulled into port for a few nights....noticed my bilge going off continually. there was a steady stream of water coming in, had boat pulled and found out the the underwater exhaust elbow was missing, which resulted in the screws leaking. I was able to fix it enough...
I have a 1995 330 and my shower drain is leaking with the typical water that gets the carpet wet. My question is how does the drain come out so I can run a new line to the sump drain box. I cannot access it from underneath......does the drain cap pop off in some fashion so it can be removed from...
I have a 5.7 Mercruiser vdrive that recently has had an issue and any help is greatly appreciated. The engine is 3 years old with 61 hr on it and has ran great until this past weekend. I put fuel in on Friday morning and idled out our channel for a 5 mile run to a local island for the weekend...
I have a 1995 330DA and my fresh water pump will pulsate off and on intermittently every 2-3 minutes. I have looked high and low for a leak and have not found one ( which is good ), all faucets are off, but cannot get it to stop. Is the pump bad ? is there a filter in these sureflow pumps that...
HI,
Funny you posted this as Im going to be doing the same to my boat this winter. Was it easy to do ? is just a silicon seal at the top to hold it in ? Where did you find the sizing for this sink as its an off shaped sink?
Thanks in advance
I blew my 5.7 last year....sicking feeling for sure, nso I feel for you. I bought a long block direct from Mercruiser....runs great to date. I looked at Jasper and Michigan Motors....cost was comparable for a new long block....good luck
I have a 330 Dancer with 5.7l and the question I have is on the engine temps. My starboard engine will read 160 and my port engine will read 170...it doesnt go any higher but i have a small concern on the 10 degree difference. Is this normal or is this something that needs to addressed ?
Thanks...
I have a 1995 Sundancer 330DA and my anchor line is shredding approx 4 in from the connection point of the anchor. I have looked where the line crosses the roller on the bottom of the windless rail and on the top roller as well and there appears to be no sharp points, has anyone else experienced...
I put the boat in the water in April and unfortunately I had an engine seize up and had to pull the boat and replace it. After the boat went back in the water my hot water tank will not heat up...it did prior to me pulling and doing the engine work, but it will not work now after....i have...
I have V Drives and I lost oil over the weekend.....it came out of the filter of the lines, I did not hear any loud bang that would have been a piston coming apart.....I replaced oil back in to see how much came and it was only 1.5 qts....so i tried to restart the engine and it did fire right...
I have a 5.7 Mercruiser with approx. 825hrs on it. Has great compression, as I was running the boat today, I noticed the oil pressure gauge go to "0", and before I could turn the engine off ,it shut down on its own. When I opened the hatch to see the issue there was oil all over the starboard...
I had my engines tested as well in the fall, I have learned to have them done at operating temp...the leak down test will determine if there is an issue with that piston...then you have some negotiating room on the overall cost of the boat.