I have a 38’ Sundancer with 8.1 HO’s.
Both engines at same time shut down.
I will get a system beep and both will shut down. No codes will come up. It is at Random times but mostly just after start up. Most times all gauges shut down and engines stay running. Only few times engines shut down as...
I have a 2006 38' Sundancer, both engines shutdown running at about 2000 RPM's.
I have heard a beep and have seen both engine gauges drop but never have had the engines both just shutdown underway?
Any ideas?
Ground fault but both engines do this at same time.
First time shutting down on me. But...
I have a 2006 Sundancer 38’.
8.1 HO engines just had injectors cleaned.
When I hit about 3600 to 4000 RPM
The port engine RPM drops to 3000 then back up then drops to 3000 then back up?
Any ideas what would cause this pulsating RPM
I lost power steering this weekend.
I have the hydraulic cap at the helm behind steering wheel.
Heading out the rudder was at 27 degree's when turning the wheel it did not show it was moving on the gage.
It is a 2006 38' Sundancer.
Thinking it might be low fluid but its a closed system so not...
I am looking to paint my 2006 38’ Sundancer’s engine compartment and a few other compartments that have chipped paint.
Any suggestions on what I should use ?
I want to match colors as close as possible and want something to adhere well.
What should the PSI be at the fuel injectors on an 8.1 HO 496 MAG?
I just sent out the injectors and 4 were not spraying good.
Had them cleaned and was told 36 PSI is what they are pushing?
1 was only spraying 7.
Does the 8.1 HO 496 MAG have a fuel pressure regulator?
If so where is it located?
I see on the fuel rail there is a dampner but do not see a regulator.
I am having issues with starboard motor.
Would not pass 3400 RPM and now dropping to 3000 to 2700 .
What would cause the plugs to look like this?
I changed the plugs and all fuel filters.
I am waiting on wires to install today and test run.
Any other potential issues causing black plugs?
I am trying to remove the older DVD player and can not seem to figure out how it comes out?
Also the mini freezer just under is not working correctly and it will not come out.
I just bought the 38' SeaRay Sundancer 2006.
Any ideas on how these come out?
I am updating carpet in my 2006 38DA.
When I pulled the Salon table mount I saw water in the well below?
This is a new to me boat. I think this runs under shower to front of boat.
Anyone run into this before?
Boat is still on blocks getting repairs sense shipping and schedule to launch in 2 weeks