Hi All,
Apologies in advance but the search removed both AC and DC from my search, so I couldn't really search for this.
Have a Norcold DE0061 that had been rock solid, but realized that the AC circuit seems to have quit. I have my dash disassembled and had the batteries off and got home from...
Hi All,
My Garmin 5212 is slowly disintegrating. Works fine, but the plastic around the screen has gotten to the point where it has cracked around all the screws holding it to the body and the screen has little shadow developing around the center.
That said, I can get one from Max Marine...
Hi All,
Did a search, but got "10 billion" results.
My fiber glass exhausts are shedding paint like crazy. Knowing that paint protects them, is there a recommendation of paint type?
Thinking a brush on epoxy type, but hoping someone can help.
TIA!
Kevin
Hi All,
I am hauling the first week of March and I want to upgrade my transducers. Have been told I could replace my transducers and the GSD 22 Sounder Network Module with a new chartplotter with integrated sounder/transducer support.
I also have perfectly functional Garmin 5212.
Can I put a...
Hi All,
Have a 99' 450 EB and have a CrusAir 8000 BTU with an SMX II control panel. Thr unit is located under the master bed. Seems like the reversing valve on the refrigerant isn't working as I select heat and it keeps making cold air.
1. Where is that valve?
2. Can I check for voltage?
3...
Hi All,
Odd question here on some older electronics.
I have a Garmin 5212 (https://www.garmin.com/en-US/p/9158) which is wifi compatible, not capable. I found a wifi adapter on ebay (https://ph.garmin.com/mobile/products/discontinued/garmin-marine-wi-fi-adapter-kit/) and have physically...
Hi All,
Pulled all four locker doors on my 99' 450 EB and found some rot. I cleaned stuff up and filled with epoxy, but my blue tape leaked. ON EVERY DOOR.
So, because it went under the tape I didn't see it and I have a few spots of cured epoxy to remove. Short of sanding, does anyone have...
Hi All,
Have a 99' 450 EB with a Raypilot 650. The chartplotter is a Garmin 5212 and works (worked) well with the Raypilot in both Auto and Nav. Had no issues with the autopilot for about 50 hours after buying the boat, and then it started.
Had the heading hold (auto) feature engaged and then...
Hi All,
Replacing the Salon A/C in a 99' 450 EB. The unit has corroded coils and seems like the control board died (no 5 VDC at the SMX-II panel).
I really want to keep the same SMX-II panel to keep congruence with the mid and fwd A/C controls.
Is this possible? If not, what are some...
Hi All,
Have a 450 EB (new to me) and knew we needed to do some repair work around the head board/side shelves in the master. They are all down about 3 inches in the front. I can easily push them back up, but I can't figure out how to get behind them to repair whatever was originally...
Hi All,
Bringing home our new (to us) boat over the weekend from Punta Gorda, FL to Destin, FL.
We were going to Tarpon Springs, but our delivery slipped twice and we don't have a slip. Expanding our serach to Clearwater and looking for suggestions from anyone with first hand knowledge.
Thx...
Hi All,
We just did sea trial and survey last week and accepted our first Sea Ray this week, a 99' 450 Express Bridge. We live on the Emerald Coast in Florida and have a deep water dock on a bayou leading to Choctawhatchee Bay. From there it is either out the Destin Pass into the Gulf or down...