Search results

No, it is only around the ski/anchor storage area in front of the gas tsnk area. Im also looking to repair the boat, not sell it. Im looking for repair advice and not an 'armchair' lawyer response. Having boat-sold or traded more tha 15 boats on Lake Michigan, I certsinly know disclosurer...

Hi All Relocated to South Florida 18 months ago Sadly had to sell (pending) my 350EB in Chicago Have a need I have an older Larson All American 17.5 ft I need to replace the flooring as noticed some soft spots over the weekend Looking for recommendations in Winter Haven , FL or South...

Looks like a great trip Mahogany Rose was in Hammond Indiana a 2 seasons ago Got to meet Dennis the owner, great guy To a cruise up to Chicago one afternoon Unbelievable boat and a great story behind it's build The interior is nothing short of spectacular The woodwork, all Mahogany with Teak...

I am looking for the Electric Panel Mounted Off-On-Intermittent Starter Switch for my Quicksilver 5.0 Generator Have finally traced down the bug and it is a bad switch Based on a Sea Ray Manual the Part Number is 345595 It has 5 terminals on the backside I have tried Flounder Pounder but...

Thanks Boatingnut The Rotella SAE 30W is all I have run in this boat for the past 10 seasons and have done oil analysis through Blackstone and have seen no changes. My concern was the label change to Diesel I did see Wal Mart still has the old label Conventional Engine Oil I'm stopping by...

OK From what I have been told The Shell Rep has told all of the Auto Parts Stores I have contacted is that the only change is to the label and the pouring system to make it easier to pour But I do see that the rating has been changed to API CJ-4 SJ and SN are no longer listed Still concerned...

I have always used Rottella 30W Engine Oil in my 1992 350 EB with 445 330 HP engines The label always read: Rottella SAE 30W Engine Oil The new Label reads: Rottella SAE 30W Diesel Engine Oil The old part number is the same and...

Same her on Wholesale Marine out of Ohio Have been buying from them for the past 10 years Never had a problem

My Bad Prince William Marina Usually once a year they post a list of overstock parts http://www.pwmarina.com/ Also try Flounder Pounder I have gotten stuff from them Dan

Double

I got my oval base through Prince Edward Marine here on this site I then went to Garlick and purchased the post and the receiver for the bottom of the table and made my own table White Laminate top with half round Oak edges I used to break it down and put it inside during the week but had...

I'll be pulling Oct 14 Had a great year On the boat every weekend Fri-Sun Made more out of harbor overnight trips this year that the past 2 years combined Helped to see $2.99 a gallon gas for a few weekends!! Trying to sneak in one more overnighter to Michigan City or Portage before the end

Stuck our bow out the Calumet Breakwall Uhh Ohhh Turned back and went to the slip and had a beer No fun out there Sunday

I'm also going to try and make up Sunday for the show Saturday looks to be a complete washout Coming up from Hammond

Can you PM me any more information? Thanks

On my boat I have a panel on the starboard entry wall with a master rocker switches for all of my interior and courtesy lights One is marked bilge lights In the bilge those lights also have their own slide switches

***

Over the summer we had 3 terrible storms go through our marina here in Hammond The first one did quite a bit of damage to my bimini canvas Luckily my canvas guy was able to make repairs Unluckily for me the later storms bent the fore and aft Stainless framework to the point that the canvas...

Fixed Bridge Height South of Chicago heading down to St. Louis is 18' Most boats heading down the loop stop in Hammond prior to leaving and lower arches, antenna and anything else to clear those bridges.

Mike Our group on the R Dock in Hammond monitor 68 to contact each other while we are out on the lake or at the beach so we can locate each other. Dan