I just bought a 97 175 5 series and some of the gauges do not work. I can not find any links to fix this. Oil pressure and up/down gauges do not work. The tachometer works, but can reads high intermittently.
Speedometer seems to be a few mph short of my cellphone GPS.
I am guessing I have a...
Any advice where I might sell these? When I bought the boat it had already made it past that point in assembly and I installed Simrad electronics system at the dealer. Now I have these four gauges - Fuel, Tachometer, Speedometer, Trim status....
Any advice is appreciated!
Joe
Looking for some help, for some reason, my gauges have stopped working, I've recently installed new digital equipment and when I went to test everything I noticed the speedo gauge and multi-gauge are not working, but the Smart Craft Guage is ok, I've checked the connector at the back of the...
Looking for some help, for some reason, my gauges have stopped working, I've recently installed new digital equipment and when I went to test everything I noticed the speedo gauge and multi-gauge are not working, but the Smart Craft Guage is ok, I've checked the connector at the back of the...
I try to bring back the boat to original.
For now it is 99% original I think. Pre owned by 1 owner for 46 years!
I am looking for an original speedometer, a fuel meter and some other small parts.
Anyone suggestions?
1998 370 DA, replaced original syncronizer gauge, hooked up wires correctly, new gauge does not work.
Original gauge works,
Easy hook up , 2 signal wires, 1 ground, 1 power, 1 light...hard to screw up.
Any feedback appreciated.
2 gauges were installed on the starboard side of the dash. One is 2" diameter while the other is 2 & 1/16th". Holes were drilled with the type of hole saws used to install door locks or deadbolts. Appearance is good despite the curved surface. This was a good spot as you can access the back...
I need to replace a faulty fuel and alternator gauge on my 2001 Sea Ray 310 Sundancer. Does anyone know where I can find new or used replacement gauges for this model?
I just bought a 1987 268 Sundancer. that needed the whole dash to be redone. The gauges and wires are fine but none of the wiring is hooked up. Where can I find a diagram for this? I could probably guess at a lot of it but would hate to have it blaze up on the water. We have a real short season...
My speedo gauge always reads zero, the analog and digital gauge, Under all conditions under power or just cruising. What controls the output, any help would be appreciated thank you, the boat is a 2006 340 sundancer with 8.1 horizons
I have a 2000 270DA with the twins. Last year, I replaced all trim senders and limit switches, and everything was working great. I just splashed this year, and neither of my trim gauges will do anything. I double cheched the senders, and they look great. I then replaced the gauges because it...
Any help in locating original or aftermarket parts for my 1986 Seville bow rider would be gratefully appreciated. Initially, I am in need of a trim gauge and a speedometer. I also need all of the railings.:huh:
Hello: I recently bought a 2003 240 SunDeck with Mercury SmartCraft Gauges. The cluster has a square LED monitor in the middle and 6 round tradition guages. The guages were working fine but becuase I just bought the boat I wanted to reset a few of screens in the SmartCraft Monitor like fuel...
She`s powered by 2 Volvo penta diesel 147kw/200pk ,gen.Westerbeke diesel
Now I have a problem with the gauges they are not working fine,rpm read only after a hard push on the trottle,psi not equel,fuel bad reading ,temp is ok ,is it the connection to the engine or are the gauges broken