Hi, I was wondering if I need to take out the whole engine just to fix that hose or could I fix it exactly where it is after I drain the oil of course?
I know I can get it from the dealer, but I am just looking for about a foot for the transom to the stern drive. I am not ready to change the hose on the engine side.
Does anyone know where to buy it by the foot? I read about fuel lines and hydraulic hose and am confused what to buy. I know...
Does anyone have a recommendation of a reputable hydraulic swim platform with pop-up chalks for a 2007 Sea Ray 44 Sedan Bridge that will hold either a jet ski or tender. Have used one firm out of FL before with a very poor experience.
Hello everyone,
I hope to find some advice here on my trim pump. It does turn on and hum however there seems to be hydraulic pressure. Yes the reservoir is full haha, I am no mechanic but I did check that much. I also pulled the lines from the rams and was still not getting any fluid from them...
Trying to get my 2005 280 Sundancer ready for the slip.. So close! (Twin 305 MerCruisers)
Ran into an issue and need your advice.
Starboard Trim-Tab - Seem to be working correctly
Port Trim-Tab - When you hit the down button you can hear a relay but nothing happens. Up button has no relay...
For anyone in the Baltimore-Washington Metro, Hydratec in Baltimore is your place to go for hydraulic and machining work. This is not an ad but a personal recommendation. Last year they rebuilt the hydraulic cylinders for our swim platform and this year they rebuilt the hydraulic pump. The...
I have what I assume is a leak in my steering lines/fittings. When I turn my steering wheel in the cabin, it will stop after a couple turns. When I turn the wheel on the flybridge, it continues to turn without stopping. It also has very delayed response in turning. Boat is a '86 Sea Ray...
Was heading out for the long weekend, (of course), soon as I engaged the stick, had severe shudder/vibration and shutdown immediately. Luckily, we were close enough to the dock to reach some lines.
Discovered the port trim tab actuator had broken at the trim tab connection, dropping the trim...
I have a 1994 500 Sundancer and after I take it out and get it warmed up the starboard transmission does not seem to engage properly. After running it for a little while if I want to go in a straight line I have to steer the rudders to starboard. When I come back into the Marina to dock (stern...
Hey guys and girls.
I have read through many steering issues on the forum but none the exact same as mine.
Here is my issue.
While at the dock or underway my Seastar steering system does a click/clunk when I turn the wheel. Its a feeling not an actual noise. It only does it in one spot and...
I'm going to attempt to add hydraulic steering fluid to the helm today and I wanted to ask the process to 'bleeding' this pump for left and right turns to get it back where it needs to be. I know it takes 2 people, so wanted to have a game plan prior to showing up.
Took my boat out in the bay a few days ago for the first time in a few months. Just had the hull and running gear cleaned "diver". I had trouble steering it seems as if there is a hydraulic leak or may be low on fluid I have no idea how or where to check it I haven't put any time into looking...
I have a 1999 Sea Ray 230 BR with the hydraulic engine compartment. Anyone know of an easy way to lift the engine compartment hatch if you have a dead battery? I haven't had this problem yet, but I want to be prepared as I boat in some remote locations!
hey everyone new to this site and any help would be great. i'm having a problem shifting back into neutral regardless of engine RPM shift cable are good. if i shut off the motor it slides right into neutral just doesn't work under a load (in the water only) i can see hydraulic lines going into...
I have a 290 Sundancer that has hydraulics to open the hatch - quit once before and they replaced the switch. They told me (when I bought it) that it could be opened manually. New service guys say it has to be hauled out - not sure how that will help open it ---anybody know anything about...