1997 240 Sundancer Rear Seat Removal

Discussion in 'General Maintenance/Repair Questions' started by Pilot Traveler, Aug 13, 2019 at 2:27 PM.

  1. Pilot Traveler

    Pilot Traveler New Member

    1
    Jul 9, 2014
    Maine
    1997 SeaRay 240DA
    5.7L
    I am working on removing the rear bench seat for recovering on my '97 240 Sundancer but am running into a problem with removal of the screws on the back side of the transom. These screws hold uprights in place that go into the rear seat back. The screws turn but I need to get at the nuts on the other side. I need to confirm if there is any other way other then through the engine compartment. There isn't much room in the engine compartment so if there is a another way to remove that back or any advice I would greatly appreciate it. Thanks!
     

Share This Page

Show Sidebar