bonding system ????

[KEVIN D TOBIN]

my ? is this, can someone show a typical bonding system and where the green wires finally end up,I mean do they end at a anode ? I've seen a few spots where a 10 ga. wire ends up with a screw thru a crimped fitting to the inside of the hull and in about 4" it starts back up again, it seems like something was there and eroded away. I haven't found one anode attached to the inside of the hull. Should there be ?

 

[ocgrant]

yes, distribution blocks and then an anode usually depending on your boats layout.

 

[KEVIN D TOBIN]

I've seen the buss bars,both bonding and dc neg. , but nt one anode, so at each point where I see a 4" space or so, there should be a anode ?

 

[ocgrant]

I've seen the buss bars,both bonding and dc neg. , but nt one anode, so at each point where I see a 4" space or so, there should be a anode ?

Not sure exactly where your anode should be on your boat. I assume you have outdrives, they should be on them. But there might be one mounted to your stern?

 

[paulswagelock]

Example system from abyc

 

[KEVIN D TOBIN]

thank you for the electrical drawing, this is the first one I've seen that included the continuity wires