Changing directional/adjustable cabin light bulbs

Ruckus

New Member
Mar 3, 2019
8
Boat Info
2006 Searay Weekender 215
Engines
5.0 Mercruiser, Alpha Drive
How do I replace the bulbs in the salon "adjustable lights" of my 2009 sundancer 310?
There are approx 7
I can't seem to figure out how to take the lens off.
 
Are they are the recess lights that pivot?

if so there are two springs that hold them to the ceiling from the inside.

if you can grab the edges with your fingers you should be able to pull them straight down until you can hold the springs from slapping back as the light comes out of the ceiling.

hope this helps.
 
Are they are the recess lights that pivot?

if so there are two springs that hold them to the ceiling from the inside.

if you can grab the edges with your fingers you should be able to pull them straight down until you can hold the springs from slapping back as the light comes out of the ceiling.

hope this helps.

I manage to change those pull down recessed lights. It’s the other bullet shaped light that swivel. They over the settee, bed and rear couch
 
I manage to change those pull down recessed lights. It’s the other bullet shaped light that swivel. They over the settee, bed and rear couch

Can you provide a picture of the fixture in question?
 
The two (left/right) next to port holes (NOT the recessed lights in the ceiling). Under the shelf. They are movable. The trim ring looks like the way to access the bulbs but it looks like you have to depress a lot of notches at the same time to release it, which seems impossible by hand. Is there a tool?
2713396_bc70bf01_1.jpg
 
I think the lens frame twists off. The two indention's go into a groove and spin to tighten.
 
I figured it out. I tried twisting the whole bezel but the design doesn't allow it. Doing so made the front lens pop out. At closer observation there are 3 indents on the lens that line up that will allow you push the lens back in once the bulb has been replaced. I will use a small diameter flat screw driver to remove the lenses from the other lights
 
I figured it out. I tried twisting the whole bezel but the design doesn't allow it. Doing so made the front lens pop out. At closer observation there are 3 indents on the lens that line up that will allow you push the lens back in once the bulb has been replaced. I will use a small diameter flat screw driver to remove the lenses from the other lights
I use a knife to pop out the lens cover. I just changed all mine to LED.
 

Forum statistics

Threads
112,948
Messages
1,422,804
Members
60,930
Latest member
Ebrown69
Back
Top